《消除光照强度干扰和相位调制幅度变化的改进的相位产生载波解调算法》由会员分享，可在线阅读，更多相关《消除光照强度干扰和相位调制幅度变化的改进的相位产生载波解调算法（6页珍藏版）》请在金锄头文库上搜索。
1、Improved phase generated carrier demodulationalgorithm for eliminating light intensitydisturbance and phase modulationamplitude variationYouwan Tong,* Hualin Zeng, Liyan Li, and Yan ZhouOptoelectronics System Laboratory, Institute of Semiconductors, Chinese Academy of Science, Beijing, China*Corresp
2、onding author: Received 26 June 2012; revised 4 September 2012; accepted 4 September 2012;posted 5 September 2012 (Doc. ID 171123); published 5 October 2012In this paper we propose a novel, improved, phase generated carrier (PGC) demodulation algorithmbased on the PGC-differential-cross-multiplying
3、approach (PGC-DCM). The influence of phase modula-tion amplitude variation and light intensity disturbance (LID) on traditional PGC demodulation algo-rithms is analyzed theoretically and experimentally. An experimental system for remote no-contactmicrovibration measurement is set up to confirm the s
4、tability of the improved PGC algorithm withLID. In the experiment, when the LID with a frequency of 50 Hz and the depth of 0.3 is applied, thesignal-to-noise and distortion ratio (SINAD) of the improved PGC algorithm is 19 dB, higher thanthe SINAD of the PGC-DCM algorithm, which is 8.7 dB. 2012 Opti
5、cal Society of AmericaOCIS codes: 060.2370, 120.3180, 120.5050.1. IntroductionRemote no-contact microvibration measurement isanimportantsubjectinscientificresearchandindus-trial manufacture. Using a laser interferometer isone of the most effective and accurate techniques1. To recover the phase-shift
6、 signal from the inter-ferometer, several phase demodulation algorithmsare available now. Among them, the phase generatedcarrier (PGC) is the most widely used for modulatingand demodulating because it has many advantagessuch as a wide dynamic range, high sensitivity,and good linearity.In the PGC dem
7、odulation scheme, a high-frequency sinusoidally modulated optical carrier isapplied to the reference beam to up-convert the de-sired vibration signal shift onto its sidebands. A pairof quadrature components are acquired by detectingone oddandone evenharmonic ofthesignalfrom theinterferometer to over
8、come the bias-induced signalfading 2. There have been some traditional ways torecover the vibration-induced phase shift from thetwo quadrature components such as the differential-cross-multiplying approach (PGC-DCM) and arctan-gent approach (PGC-arctangent).The linearity of the demodulation algorith
9、m andthe ability of eliminating the light-intensity distur-bance are of great importance. The demodulationresult of the PGC-DCM approach is related to thelight intensity 35, and the linearity of the PGC-arctangent approach depends on the phase modula-tion amplitude. 58 Consequently, the method thati
10、s not influenced by light intensity and phase modu-lation amplitude is still needed.2. Principles and analysisA. PrinciplesFigure 1 shows the schematic of the improved demo-dulation algorithm. The phase carrier can be appliedto the reference beam by an acoustic modulator or a1559-128X/12/296962-06$1
11、5.00/0 2012 Optical Society of America6962 APPLIED OPTICS / Vol. 51, No. 29 / 10 October 2012piezoelectric transducer (PZT). The interferencesignal received by the photodiode is given byI.0133t.0134.0136A .0135 B cos.0137C cos.01330t.0134.0135.0133t.0134.0138; (1)where A and B are the dc and ac comp
12、onents respec-tively, A and B depend on the light intensity of thesignal beam and the reference beam. C is the PGCphase modulation amplitude, 0is the PGC modula-tion frequency, and .0133t.0134 is the desired phase-shiftsignal which is related with the vibration of the ob-ject we are concerned about
13、and the low-frequencyenvironmental noise mainly introduced by the varia-tion of the refractive index of air. So we assume thatthe vibration signal is a single-frequency signal and.0133t.0134 can be written as follows:.0133t.0134.0136D cos.0133st.0134.0135.0133t.0134; .01332.0134whereDistheamplitudeo
14、fthevibrationsignal,sisthe frequency of the vibration, and .0133t.0134 is the lowfrequency environmental noise.Firstly, the interference signal is separately multi-plied with the fundamental carrier, the second-harmonic carrier, and the third-harmonic carrier.The carriers have already been synchroni
15、zed withthe interference signal 9. After the high-frequencycomponents are filtered out by three low-pass filters,and L1.0133t.0134, L2.0133t.0134, and L3.0133t.0134 are obtained:L1.0133t.0134.0136BJ1.0133C.0134sin .0133t.0134; (3)L2.0133t.0134.0136BJ2.0133C.0134cos .0133t.0134; (4)L3.0133t.0134.0136
16、BJ3.0133C.0134sin .0133t.0134; .01335.0134where J1.0133C.0134, J2.0133C.0134, and J3.0133C.0134 are respectively thefirst-order, second-order, and the third-order Besselfunctions with C. Subtracting L3.0133t.0134 and L1.0133t.0134 yieldsE.0133t.0134.0136L3.0133t.0134L1.0133t.0134.0136 BJ3.0133C.0134sin .0133t.0134.0135BJ1.0133C.0134sin .0133t.0134.0136 B.0137J3.0133C.0134.0135J1.0133C.0134.0138sin .0133t.0134: (6)According to the recurr
