《GSM 8PSK Signaling test》由会员分享,可在线阅读,更多相关《GSM 8PSK Signaling test(14页珍藏版)》请在金锄头文库上搜索。
1、GSM 8PSK Signaling test SOP1. Start up the phone and connect the MLB with CMW 500 and PC as following.2.DUT go to test mode2.1 Click the” ttermpro “and set as following pictures2.2 Open DC power, when :-) appeared, Type “diags” command enter DUT to Diags modeInput bbon, then input base -send_cmd “29
2、 04 00” to get in the online mode.Then input the command: base -send_cmd “4B FB 0A 00 04 00”3. Change the IP address:Connect CWM500 as below:Input the password “instrument” on the box and click “OK” or press “Enter”. 4.Set CMW 5004.1 Press “Ctrl+G” open generator window, and select GSM-Signaling mod
3、e.4.2 Click “GSM Signaling” and Set parameters in it as follow picture.4.3 Click “config” and set parameters in it as following,when we finish it and please press “Ctrl+enter” to turn on “GSM Signaling”.4.4 Press “Ctrl+M” enter to “Measurement Controller” interface and select GSM- Multi Evaluation.4
4、.5 Select “Measurement Controller” and click “config” then set parameters in it as following, then press “Ctrl + Enter” to make it run.5. Connection 5.1 We finish above steps and we will see the next interface in CMW500, then click “PS Connect”.5.2 After click “PS Connect” and wait for next interfac
5、e occurs.6. Test items 6.1 Press “Ctrl + Enter” to make the test run in the Multi Evaluation window. Then it will show out the test result. 6.1 Select “Display” and click “select view”, we can select what we want to test item, or double click the small window. e.g Power vs. Time 6.2 If you want to return the overview, click the soft button “Display” and “Select View”, and click “overview” on the list of menu.1 13 3