《商用车空气悬架介绍及概念设计》由会员分享，可在线阅读，更多相关《商用车空气悬架介绍及概念设计（34页珍藏版）》请在金锄头文库上搜索。
1、G.LeiberichIntegrated DynamicsAir Suspension 空气悬架空气悬架G.LeiberichIntegrated DynamicsAdvantages 优点优点3/2 way valve for quick exhaust e.g. on ferries operation (depend to version) 用于快放的3/2阀，如轮渡操作（取决于变型） 2 nd ride height (depend to version) e.g. on lift axles, for different saddle heights, as kneeling“ o
2、n busses 第二行使高度（取决于变型），如在提升桥上， 用于不同鞍座高度，客车的侧跪系统Height limitation (depend to version) 高度限制功能（取决于变型）Quick exhaust (depend to version) 快放功能（取决于变型）Flow rate170 l/min up to 620 l/min (depend to version) 流量从170l/min到620l/min(取决于变型）With cross restriction to stop the vehicle becoming unstable when cornering
3、 通过横向限流使车辆转弯时更稳定EGP = Engineering Grade Plastic 工程塑料工程塑料G.LeiberichIntegrated DynamicsEGP = Engineering Grade PlasticThis valve is used for levelling purposes in air suspension systems. Variations in the height of the chassis resulting from load variations are equalized by inflating or deflating the
4、 air suspension bellows in proportion to the respective loads carried by the vehicle. For increasing the stability in curves there is the possibility to get this valves with a cross restriction between the both delivery ports. For vehicles with a raise/lower valve it is possible to install a levelli
5、ng valve with a height limitation device. If the chassis will be raised by using the raise/lower valve the height limitation device will cut the pressure for the port No. 1 of the raise/lower valve when the maximum height of the chassis is reached, so that the chassis cannot be raised anymore. 高度阀的作
6、用是用于空气悬架系统中高度控制根据车辆的载重情况，通过向空气悬架气囊充气和放气，来控制 车辆底盘的高度为了增加转弯时的稳定性，高度阀两出气口之间可有横向限流作用 对于具有底盘提升阀的车辆来说，可安装带高度限制装置的高度阀底盘通过提升阀提升高度时，如果底盘高度 达到最大时，高度限制装置会切断提升阀号口的气压，底盘不能再升高.G.LeiberichIntegrated DynamicsILAS -E 车桥提升阀车桥提升阀ISO 7638EGP 高度阀高度阀COLAS 底盘升降阀底盘升降阀ISO 1185EB+EGP = Engineering Grade Plastic 工程塑料工程塑料G.Lei
7、berichIntegrated DynamicsVersions 变型变型612 035 011 DN = 1.25 mm, Linkage losely enclosed, M12 x 1.5 (replacement 612 017 061)包括控制杆,散装,接口尺寸M121.5 612 035 021 DN = 3.00 mm, Linkage losely enclosed, M12 x 1.5 (replacement 612 017 091)612 035 031 DN = 4.00 mm, Linkage losely enclosed, M12 x 1.5 (replacem
8、ent 612 017 111)612 035 001 DN = 3.00 mm, without Linkage, 1/4“ - 18 NPTF (replacement 612 023 251)不包括控制杆,接口尺寸1/4“ - 18 NPTF 612 035 011 DN = 1.25 mm, without Linkage, 1/4“ - 18 NPTF (replacement 612 023 211More versions on request 可根据需要提供更多变型EGP = Engineering Grade PlasticG.LeiberichIntegrated Dyna
9、micsTechnical data 技术参数技术参数-Operating pressure, dyn.: pe max. 13 bar 工作压力 -Perm.dyn. bellow pressure: pe max. 20 bar 允许气囊压力-Operating temperature: - 45C to + 85C 工作温度- Operating range (charging and exhausting): 45 工作范围（充气和放气） -Side of control:on the left and on the right 控制位置左边和右边 -Dead angle at pe
10、= 7 - 8 bar:2 关闭区(非调整区)EGP = Engineering Grade PlasticG.LeiberichIntegrated DynamicsLevelling valve with height limitation and 2nd ride height 具有高度控制和第二高度的高度阀具有高度控制和第二高度的高度阀G.LeiberichIntegrated DynamicsLevelling valve with height limitation 带高度控制的高度阀带高度控制的高度阀ReservoirLift axle valve 提升桥阀提升桥阀Lift be
11、llow 提升气囊提升气囊Raise/lower valve 底盘升降阀底盘升降阀Ride height 行驶高度行驶高度G.LeiberichIntegrated DynamicsLevelling valve with height limitation Automatic Lower; 8 mm push in 手动升高和降低;自动降低;8mm插头 - 352 049 .Manual Lift and Lower; Automatic Lower; M12x1.5- 352 051 .Automatic Lift and Lower; 8 mm push inMore versions
12、on request 根据要求可提供更多变型G.LeiberichIntegrated DynamicsILAS- E is the consistent further development of the known and approved ILAS system. ILAS- E has got even more compact in comparison with his predecessor. ILAS- E becomes raising controlled electrically and one or more lowers lift axles at conventi
13、onal air suspension systems used. A load dependent output signal switches ILAS- E at braking systems regulated electronically by an electrical signal. G.LeiberichIntegrated DynamicsILAS- E 是比ILAS 系统更先进的新一代产品. 相比于前代产品， ILAS- E结构更紧凑. ILAS- E 是电控的用于传统空气悬架系统一个或多个提升桥的升降. 载荷控制式输出信号,通过电信号控制在电控制动系统中的 ILAS-
14、E G.LeiberichIntegrated DynamicsTechnical data技术参数-Operating pressure:pe= 8.5 bar 工作气压-Voltage:24 VDC 电压-Permissible duty:100% 允许负荷-Operating temperature:- 40 up to + 80 C 工作温度-4 ports: M 16x1.5 or push-in fittings for plastic tube 8x1 气口: M 16x1.5 或快接插头8x1尼龙管G.LeiberichIntegrated DynamicsUse用途用途 Co
15、nventional air suspension systems For EBS-systems: output signal controls ILAS-E Controlled by pressure switch 传统的空气悬架系统 对EBS系统：输出信号控制ILAS-E 压力开关控制 Versions种类 352 061 001: Thread螺纹 M 16x1.5 352 062 001: Push-in fittings for plastic tube 8x1 快插接头8X1尼龙管Function功能功能 Electrical operated Lift axle contro
16、l device 电控提升桥控制装置 With power: axle is lifted 有电：桥被提升 Without power: Axle is down 无电：桥被放下G.LeiberichIntegrated Dynamics4111121221212122Brake system with EB+ and ILAS-E 带带EB+和和ILAS的制动系统的制动系统G.LeiberichIntegrated DynamicsTechnical datas技术参数技术参数Operating pressure:max. 8.5 bar 工作压力工作压力Voltage:24 VDC 电压电压Permissible duty: 100% 允许负荷允许负荷4 ports: M 16x1.5 or push-in fittings for plastic tube 8x1 气口气口: M 16x1.5 或快接插头或快接插头8x1尼
