人力资源管理概论结课论文

上传人:xins****2008 文档编号:112229035 上传时间:2019-11-05 格式:DOC 页数:10 大小:271KB
返回 下载 相关 举报
人力资源管理概论结课论文_第1页
第1页 / 共10页
人力资源管理概论结课论文_第2页
第2页 / 共10页
人力资源管理概论结课论文_第3页
第3页 / 共10页
人力资源管理概论结课论文_第4页
第4页 / 共10页
人力资源管理概论结课论文_第5页
第5页 / 共10页
点击查看更多>>
资源描述

《人力资源管理概论结课论文》由会员分享,可在线阅读,更多相关《人力资源管理概论结课论文(10页珍藏版)》请在金锄头文库上搜索。

1、step shape, control of step size, set aside a decoration project, to run up and down the stairs the same faade stepping angle. 4.4 reverse triangular plate is in the Middle bench, reinforcement time side boards. Reverse triangular plates consist of a number of triangular pieces of wood nailed to the

2、 wood, and two triangular wood blocks high and wide of the right angle equal to step on a side, timber section for 50mmx100mm and third corner Board with bench support cross-ridged fixed between the side plates. 4.4 (1) expansion joints template support set: first support good expansion joints side

3、of wall template (wall sides are for multilayer Board), stay its concrete pouring Hou, will its template demolition, again support another side wall template, but this wall by expansion joints side with 200 thick high-density squeeze plastic poly benzene Board for template, another side for multilay

4、er Board, expansion joints North-South State surface the with 200x200 thick multilayer Board box for across die, to control expansion joints of upper and lower vertical degrees. 4.4 (2) treatment of construction joints: this construction is not the principle of construction joints, such as construct

5、ion joints, subject to the following requirements: construction joint in beam and plate with steel mesh or wood-mode blocked. Attention to the retention of construction joints must be perpendicular to the axis of the beam and plate, shall remain oblique Cha. Before the next concrete pouring, constru

6、ction joints of concrete should be cutting hair, and loose stones should be left floating pulp, water and moist. 5 construction considerations 5.1 template installation, upper and lower column formwork system should be installed on the same vertical line. 5.2 templates on each floor after installati

7、on, should release agent brush template. 5.3 for the joints is greater than 2mm, paste the crack tape. 5.4 no hard hit when stripping pry, to prevent damage to the template and the pouring of concrete. 6 quality standard for reached concrete of standard, we according to concrete structure engineerin

8、g construction quality acceptance standard (GB50204-2002) developed has internal control standard, as Xia by shows: concrete quality internal control standard project allows deviation national standards internal control standard axis location 5 3 end of die Shang surface elevation 5 3 adjacent two B

9、oard surface level poor 2 2 surface flat degrees 5 3 pre buried plate center line location 3 3 pre buried tube, and reserved hole center line location 3 3 pre buried bolt center line location 2 2 Exposed length +10,0 +10,0 reserved hole center line position 10 10 section size +10,0 +10,0 reinforcing

10、 the centerline location 5 5 exposed length +10,0 +10,0 die frame support must have sufficient strength, rigidity and stability, supporting parts must have sufficient support area. Template size is accurate, seam marks neat and orderly. Structures of yin and Yang founder straight, joint width shall

11、not exceedrapid development of the market economy environment to explore public servants duty consumption monetization reform has provided a good foundation. The socialization of rear service work has been launched, and rapid progress in some places and departments, duty consumption monetization of

12、carrier and approach to management has been resolved. Third, in recent years, exploring the monetization of duty consumption has made some progress, have gained some experience and can provide reference to the comprehensive reform of the system of public servants duty consumption further. Implementi

13、ng an honest canteen, standardize official entertaining management; enhancing the telecommunication expense management; elimination of County travel and countryside subsidies; research village officials capitalization management of corporate spending, and so on. Finally, group .18 session to be held

14、 in Beijing from November 9, 2013 to 12th. 35 years ago blew the third plenary session of the reform and opening up in the spring breeze, changed, affect the world; today, 35 years later, in the eyes of the nation and the world expect, again to reform mark China, ushered in the 18 session. XI Genera

15、l Secretary pointed out that Chinas reform has entered a crucial period and the Sham Shui Po District, must be based on greater political courage and wisdom, lose no time in deepening reform in important fields. Dares to crack a hard nut, dares to question the Rapids, which dares to break the barrie

16、r of ideas, and dare to benefit cure barriers. Deepening reform and opening up is on schedule to achieve institutional safeguards of the moderately well-off. Under the five in one the General layout of socialist modernization requirements, 18 session of the decision was a five in one and the improvement of overall scheme of reform, will promote an integrated and coordinated economic, political, cultural, social and ecological civilization construction of the five reform

展开阅读全文
相关资源
正为您匹配相似的精品文档
相关搜索

最新文档


当前位置:首页 > 大杂烩/其它

电脑版 |金锄头文库版权所有
经营许可证:蜀ICP备13022795号 | 川公网安备 51140202000112号