《滚动码遥控器学习方法》由会员分享，可在线阅读，更多相关《滚动码遥控器学习方法（3页珍藏版）》请在金锄头文库上搜索。
1、学习、滚动码遥控器学习方法（SR500C） 1、按0.5秒接收板上的学习按钮，然后连续按住需要配套的遥控器遥控器上任意一个按键2秒钟，即可完成学习过程，如果要增加遥控器可以重复以上过程，接收板最多可以学习15个遥控器。接收板或遥控器长期断电也能记忆已经学习成功的遥控器。2、 如果连续按住接收板上的学习按钮超过8秒，接收板上的指示灯会熄灭，可以全部删除所有已经学习的遥控器。（在遥控器丢失的情况下可以用此方法）删除:按住学习按键不放，直到学习指示灯熄灭，控制里学习过的遥控器全部删除。 3、该“学习”的功能可废除旧“钥匙”配制新“钥匙”，如果遥控发射器丢失，也不必担心，重新配一个即可。 4、现在使用
2、的301用电子运算法，与汽车遥控钥匙相同；32位元密码（2的32次方），能提供超过40亿种的组合。即40多亿个不会重复。 B常闭；G公共；K常开；L锁存；M点动SR500C ROLLING CODE RECEIVER BOARD MANUALPROGRAM A TRANSMITTER TO THE RECEIVERYou need to do the programming in order to add the transmitter to thereceiver.1. Press and hold the learn button on the left side of the recei
3、ver board for 0.5 second.2. Press any assigned button of the transmitter you want to program to the receiver continuously for 2 seconds, then the programming will be completed.3. To program another transmitter to the receiver, repeat process 1 to 2.NOTE1. One receiver board can handle up to 15 trans
4、mitters, once programmed, both the transmitter and the receiver will store the information for a long term even if the power supply is cut off.REMOVE TRANSMITTER FROM THE RECEIVERYou can delete the transmitter from a receiver.1. Press and hold the learn button on the left side of the receiver board
5、for 8 seconds, the LED on the receiver will be extinguished, All the transmitters and keypads are deleted. ( This will be useful if you lost your transmitter. )NOTE1. Our product is equipped with HCS301 which utilizes Microchips patented KEELOQ hopping technology which incorporates high security, that makes our product a very secure unit.BClose GPublic KOpen L/MLatch/Momentary
