《土木工程外文翻译》由会员分享，可在线阅读，更多相关《土木工程外文翻译（13页珍藏版）》请在金锄头文库上搜索。
1、本科毕业设计外文资料翻译1 英文题目 ：Talling building and Steel construction2 中文题目 ： 高层结构与钢结构学院（部）：土木建筑学院专业班级：学生姓名：指导教师：XXX助教2012年06月02日外文资料Talling building and Steel construction精品文库Although there have been many advancements in building construction technology in general. Spectacular archievements have been made in
2、 the design and construction of ultrahigh-rise buildings.The early development of high-rise buildings began with structural steel framing.Reinforced concrete and stressed-skin tube systems have since been economically and competitively used in a number of structures for both residential and commerci
3、al purposes.The high-rise buildings ranging from 50 to 110 stories that are being built all over the United States are the result of innovations and development of new structual systems.Greater height entails increased column and beam sizes to make buildings more rigid so that under wind load they w
4、ill not sway beyond an acceptable limit Excessive lateral sway may cause serious recurring damage to partitions, ceilings.and other architectural details. In addition,excessive sway may cause discomfort to the occupants of the building because their perception of such motion.Structural systems of re
5、inforced concrete as well as steel take full advantageof inherent potential stiffness of the total building and therefore require additional stiffening to limit the sway.In a steel structure for example the economy can be defined in terms of the total average quantity of steel per square foot of flo
6、or area of the building Curve A in Fig .1 represents the average unit weight of a conventional frame with increasing numbers of stories. Curve B represents the average steel weight if the frame is protected from all lateral loads. The gap between the upper boundary and the lower boundary represents
7、the premium for height for the traditional column-and-beam frame Structural engineers have developed structural systems with a view to eliminating this premium.Systems in steel. Tall buildings in steel developed as a result of several types of structural innovations. The innovations have been applie
8、d to the construction of both office and apartment buildings.Frame with rigid belt trusses. In order to tie the exterior columns of a frame structure to the interior vertical trusses a system of rigid belt trusses at mid-height and at the top of the building may be used. A good example of this syste
9、m is the First Wisconsin Bank Building(1974) in Milwaukee.Framed tube. The maximum efficiency of the total structure of a tall building, for both strength and stiffness to resist wind load can be achieved only if all column element can be connected to each other in such a way that the entire buildin
10、g acts as a hollow tube or rigid box in projecting out of the ground. This particular structural system was欢迎下载2精品文库probably used for the first time in the 43-story reinforced concrete DeWitt Chestnut Apartment Building in Chicago. The most significant use of this system is in the twin structural st
11、eel towers of the 110-story World Trade Center building in New YorkColumn-diagonal truss tube. The exterior columns of a building can be spaced reasonably far apart and yet be made to work together as a tube by connecting them withdiagonal members interesting at the centre line of the columns and be
12、ams. This simple yet extremely efficient system was used for the first time on the John Hancock Centre in Chicago, using as much steel as is normally needed for a traditional 40-story building.Bundled tube With the continuing need for larger and taller buildings, the framedtube or the column-diagona
13、l truss tube may be used in a bundled form to create largertube envelopes while maintaining high efficiency. The110-story Sears RoebuckHeadquarters Building in Chicago has nine tube bundled at the base of the building inthree rows. Some of these individual tubes terminate at different heights of the
14、 building,demonstrating the unlimited architectural possibilities of this latest structural concept.The Sears tower, at a height of 1450 ft(442m), is the world s tallest building.Stressed-skin tube system. The tube structural system was developed for improving the resistance to lateral forces (wind
15、and earthquake) and the control of drift (lateral building movement ) in high-rise building. The stressed-skin tube takes the tube system a step further. The development of the stressed-skin tube utilizes the fa?ade of the building as a structural element which acts with the framed tube, thus providing an efficient way of resisting lateral loads in high-rise buildings, and resulting in cost-effective column-free interior space with a high ratio of net to gross floor area.Because of the contribution of t
