《EC-Declaration-of-Conformity-V.2》由会员分享，可在线阅读，更多相关《EC-Declaration-of-Conformity-V.2（1页珍藏版）》请在金锄头文库上搜索。
1、EC Declaration of ConformityThe undersigned, supplier Company NameCompany addressMust to haveCompany Town + Post CodeCompany CountryHerewith declares that the product Product nameProduct identification Model-Seriesis in conformity with the provisions of the following EC Directive(s) when installed a
2、nd used in accordance with the installation instructions and user manual contained in the product documentation :You may need to list here 97/23/EC Pressure Equipment Directive, if pressure vessels are used in your machine.98/37/EC Machine Directive2006/95/EC Low Voltage Directive2004/108/ECEMC Dire
3、ctiveand that the standards and/or technical specifications referenced below have been applied :EN 60204-1: 2006 is required to be listed. But not all the rest norms listed here are must to be stated in the DOC. Choose the ones you follow. EN ISO 12100-1 : 2003 Basic concepts, general principles for
4、 Design : Basic terminology, MethodologyEN ISO 12100-2 : 2003Basic concepts, general principles for Design : Technical PrinciplesEN 415-3 : 1999Safety of packaging machines Part 3 : Form, fill and seal machinesEN ISO 13850 : 2008Emergency Stop, Principles for Design.EN 953 : 1997Guards General requi
5、rements for the design and construction of fixed and movable guards.EN ISO 14121-1 : 2007Risk assessment Part 1 : PrinciplesEN 60204-1 : Electrical Equipment of Machines part 1 : general requirementsEN 60034-9 : 2005Noise limitsEN 61000-6-4:2001Electromagnetic compatibility (EMC) Part 6-4 : Generic
6、standards Emission for industrial environmentsEN 61000-6-2:2001Electromagnetic compatibility (EMC) Part 6-2 : Generic standards Immunity for industrial environmentsYou may not involve any notified body to do specific test. In this case, you can take this session out.Or if you do the test according t
7、o module A, just list A there.Also check if EN 349:1993, EN 811:1996 appliesA machine corresponding with the abovementioned type and model has been type tested according module B (or Module G?) and found in compliance with the above by following notified body: Name of Notified BodyAdress of Notified
8、 BodyTown + Post Code + Country + ID number EC type-examination Certificate number + Date (yr/month/day)The Technical Construction file is kept at the abovementioned suppliers address.For Making, our vendors do not have the Software, URD, final Process summary and Overall Risk Assessment, its better
9、 to state the documentation is kept at our plant and list the plant name, address etc here.This declaration of conformity is issued under the sole responsibility of the manufacturer. I declare on behalf of the manufacturer that the machine mentioned above complies with all essential requirements in the way specified and is conformity with the type for which above mentioned EC type examination certificate has been issued.Name and functionManufacturer stampSignature and titleDate and place of issue
