《[电信]alcatel分宜割接扩容步骤》由会员分享,可在线阅读,更多相关《[电信]alcatel分宜割接扩容步骤(2页珍藏版)》请在金锄头文库上搜索。
1、Use MANUAL Type.THE FIRST STEP :Modify IP Address on DSLAMusername:SUPERUSERpassword:ANS#1501.In order to confirm the DSLAM belonging to which network point, you should check IP Address at firstly. RTRV-IPPORT Check IP Address RTRV-ATMARPENT Check AWS IP Address RTRV-NE Check Network Element Address
2、2.Delete IP Address set secondly SET-NE Choose None DLT-ATMARPENT Input IP Address route to 7411(old) you want to delete DLT-IPPORT Execute directly 3.Set new IP Address finally ENT-IPPORT Input IP Address and Subnet Mask ENT-ATMARPENT Input IP Address route to 8750(new) SET-NE Input IP Address rout
3、e to 8750(new)the new IP address you should discuss with the staffs of XingYu telcom.THE SECOND STEP: After these steps finish, you will ping the new IP address on the new SUN work station. If successfully, the following steps you should do, otherwise problem must exist. 1.create the HD subrack; 2.c
4、reate NT, LT, Alarm board in the subrack ( dont need to create the user again, because the data are save in the ASAM, not in the sun workstation) 3.Upgrade the NT board form version 4.139 t0 42.040,before this the 42.040 software should be download to the ASAM),during the step ,the ASAM will restart ,all the users will disconnect form internet . About this ,you should explain to the staff and make them understood. 4.after the third step success, you can create UD combo subrack in the extend rack, all the next steps you have experienced with me before.Wish you success! Licheng 2002.12.30