《ansys 12.0 cfx 官方教程》由会员分享，可在线阅读，更多相关《ansys 12.0 cfx 官方教程（7页珍藏版）》请在金锄头文库上搜索。
1、Appendix E Licensing,Introduction to CFX,License Preferences,Workbench license control is handled through the user interface shown below, activated from the Workbench project page (“Tools License Preferences . . . “).,License Preferences,With the available licenses displayed, the activation and “use
2、 order” can be specified using the up/down arrows. 0 = off, 1 = on License order represents the preference order for license use.,The license control allows Workbench users to specify whether a single license is used when multiple applications are open, or if all open applications access their own l
3、icense.,License Preferences,In the example shown, a user could have 3 Mechanical models open simultaneously. Using the license control they may choose to open 3 licenses or use only 1 that is shared. In the shared scenario, only the active Mechanical session uses the license (the remaining will be r
4、ead only).,CFD Products,You may have purchased the following bundled products A bundled product provides access Meshing, a CFD Pre-processor, a CFD Solver and a Post-processor, running 1 task at a time “ANSYS CFD” Run ANSYS Meshing, CFX-Pre, CFX-Solver, CFD-Post or FLUENT “ANSYS CFX” Run ANSYS Meshi
5、ng, CFX-Pre, CFX-Solver or CFD-Post “ANSYS FLUENT” Run ANSYS Meshing, FLUENT or CFD-Post “ANSYS CFD-Flo” A reduced capability version of CFX MFR, DES/SAS, Monte Carlo Radiation model, Inhomogeneous Multiphase and Combustion cannot be run Run ANSYS Meshing, CFX-Pre, CFX-Solver or CFD-Post,CFD Product
6、s,You may also have purchased the following modular products: Again, each product allows you to run only 1 task at a time “ANSYS CFD Solver” Can run FLUENT, CFX-Pre or CFX-Solver “ANSYS CFX Solver” Can run CFX-Pre or CFX-Solver “ANSYS FLUENT Solver” Can run FLUENT “ANSYS PrepPost” Can run ANSYS Mesh
7、ing, CFX-Pre, CFD-Post or FLUENT Pre/Post-processing, but no solvers “ANSYS CFD-Post” Can run CFD-Post “ANSYS CFD HPC” Parallel licenses for use with either CFX or FLUENT,Some CFX Related Products,In addition to the core CFD products, the following are some of the related products available “Design
8、Modeler” None of the CFD products come with DM “MCAD Connections” Connections to CAD systems, Parasolids and SAT files DM can import some files (IGES, STEP, Parasolids,) without additional licenses, but this does not give a direct connection to a CAD system “DesignXplorer” Optimization studies (basi
9、c parametric studies are built-in to Workbench) “ANSYS ICEM CFD” Advanced meshing (Hex, Cartesian, ) “Turbogrid” Automated high quality Hex meshing for turbomachinary applications “BladeModeler” Automated geometry creating for blade designers “Vista TF” Streamline curvature through-flow turbomachinary code,
