《缝纫机送料板夹和导块间隔调整》由会员分享，可在线阅读，更多相关《缝纫机送料板夹和导块间隔调整（2页珍藏版）》请在金锄头文库上搜索。
1、SPS/A-B1306 Series14Fig. 11) Fig. 1 (4EA) .Loosen the screw(4EA) of the feed plate clamp cover.解開送料板夾固定絲 （4EA）。Fig. 22) Fig. 2 (2EA) .Loosen the screw(2EA) of the feed plate clamp cover.送料板夾盖固定絲 （2EA）。Fig. 33) Fig. 3 () .Disassemble the upper feed plate(Assy) to check whether the feed plate clamp is
2、 deformed or foreign materials are stuck inside. After the check, adjust the upper feed plate to the original position. 分離上送料板 （組） ，確認送料板夾變形或物質狀況后， 調到正常狀況。1-3 Adjusting the Clearance between the Feed Plate Clamp and the Feed Plate Clamp Guide Block送料板夾和導塊間隔調整MMFig. 44) Fig. 4 .If abnormality is foun
3、d on the feed plate clamp, loosen the screw and replace the feed plate clamp.如果送料板夾發生故障，解開固定絲后換。http:/ http:/Maintenance Book01JAMCLEARANCE負荷間隔15Fig. 55) Fig. 5 .Insert the feed plate clamp into the bracket and tighten the screw of the feed plate clamp cover.支架揷入送料板夾，然后按上夾盖固定絲。Fig. 77) Fig. 7 .Manually move the feed plate up and down to check jam and clearance.手動移動送料板，確認負荷或間隔。Fig. 66) Fig. 6 .Tighten the screw of the feed plate clamp cover.安上夾盖固定絲。M
