《七氟丙烷(hfc-227ea)灭火系统设计说明-中英文对照》由会员分享，可在线阅读，更多相关《七氟丙烷(hfc-227ea)灭火系统设计说明-中英文对照（8页珍藏版）》请在金锄头文库上搜索。
1、七氟丙烷（HFC-227ea）灭火系统设计说明中英文对照1 / 81一. 设计范围 SCOPE OF WORK：本工程共有一个防护区,采用了一套分配系统予以保护. There is ONE zone protected with installation of one set of equipment.二. 设计条件 DESIGN CRITERIA: 1. 保护区的有关参数：见附表. Design data: per schedule attached.2. 采用一套分配系统进行保护. One set of equipment is to be provided.3. 保护区为独立封闭区间.
2、Protected area is totally enclosed.4. 保护区平时环境温度与自然环境温度相同. Environmental condition of the protected area is same as surrounding area.5. 保护区均设置通风设备. Ventilation system is provided in protected area.6. HFC-227ea灭火系统瓶站设置在保护区内. FM200 container is located within protected area. 7. 瓶组间的楼板应能承载储瓶组的重量. Floor
3、structural design shall be capable to withstand the weight of the FM200 container equipment.三. 设计 DESIGN： 1. 设计依据 DESIGN COMPLIANCE 1) To comply to GB50307-2005气体灭火系统设计规范Regulation for fire fighting gas system design； 2) To comply to GB50263-97气体灭火系统施工及验收规范Regulation for fire fighting gas system ins
4、tallation and inspection/acceptance； 2. 灭火方式FIRE EXTINGUISHING METHOD: 本设计采用全淹没式灭火系统,在规定的时间内,喷射一定浓度的七氟丙烷灭火剂,并使其均匀地充满整个保护区,此时能将在其区域里任一部位发生的火灾扑灭. Fire extinguishing is by total flooding method. Within specified time limit, FM200 gas shall be discharged to the concentration as designed for total floodi
5、ng and able to extinguish the fire in any location within the protected area.3. 灭火系统的控制方式为自动、电气手动、机械手动三种.在有人工作或值班时,采用电气手动控制；在无人的情况下,采用自动方式. 自七氟丙烷（HFC-227ea）灭火系统设计说明中英文对照2 / 82动、手动控制方式的转换,在灭火控制盘上实现（在保护区的门外设置手动控制盒, 手动控制盒内设有紧急停止与紧急启动按钮.） The fire extinguishing system shall be able for automatic control
6、, electric control and mechanic control. Manual electric control shall be adopted with attendant; automatic control shall be adopted when without attendant; changeover of automatic and manual electric control could be set on the control panel installed at outside of the protected area. Emergency sto
7、p button shall be provided on the manual control panel.4. 保护区的要求Requirement inside protected area： 1）保护区为独立区域 Protected area shall be isolated. 2）保护区的耐火极限0.5h,耐压强度1200Pa - Fire rating of the protected area shall be 0.5 hour, mechanical strength shall be 1200Pa. 3）保护区的通风系统在喷放七氟丙烷灭火剂前应关闭,并设置防火阀门. All
8、ventilation system shall be stopped with damper closed before FM200 gas is discharged.4）保护区的门应采用装有自动闭门器的防火门,保证在任何情况下均能从保护区内打开. Door of protected area shall be self-closing and fire rated and able to be opened to outside at any condition.5）在保护区外设置声光报警及释放信号标志. Sound and light alarm and gas discharge s
9、ignal shall be installed at door outside of protected area.6）为保证人员的安全撤离,在释放灭火剂前,应发出火灾报警,火灾报警至释放灭火剂 的延时时间为30秒. Fire audio and visual alarm shall be raised 30 second before gas emission to ensure people inside could evacuate safely.7）为保证灭火的可靠性,在灭火系统释放灭火剂之前,应保证必要的联动操作. 即灭火系统在发出灭火指令时,由控制系统发出联动指令,切断电源、关闭
10、或停止一 切影响灭火效果的设备. To ensure the reliability of the system, before gas emission, all interconnecting operation shall be closed and stop the equipment which would affect the gas extinguishing.七氟丙烷（HFC-227ea）灭火系统设计说明中英文对照3 / 838）保护区内设有排风设备,灭火剂喷放后,人手启动将废气排尽,人员方可进入进行检修. Gas extraction equipment shall be p
11、rovided. Before people entering the protected area after release of the FM200 gas, manual operation shall be able to extract all foul air inside.9）灭火系统的使用环境温度为0C50C. Operation condition of the gas extinguishing system shall be 0oC to 50oC.10） 设计计算结果：见附表 Design calculation is as attached.四. 安装 INSTAL
12、LATION1. 安装分为（HFC-227ea）灭火系统瓶组和喷嘴管路系统,根据设计图及现场情况进行. Installation include （HFC-227ea）gas container and emission nozzle and pipe work as depicted on design drawing and site condition.2. 灭火系统瓶组设置框架,保证设计尺寸,固定牢固,操作观察方便,外形美观. Gas container frame dimensions and appearance shall be easy for operation and ch
13、ecking and securely fixed.3. 管材采用无缝钢管,法兰连接,应符合GB8163输送流体用无缝钢管的规定. All pipe work shall be seamless type, flanged joint to GB8163 (regulation for fluid delivery tube, seamless type). 4. 分布管系的水平定向敷设坡度,取顺向13/1000. Pipe work installation gradient shall be 13/1000.5. 未说明之处需严格按照GB50263-97气体灭火系统施工及验收规范进行施工.
14、 Unspecified work shall comply to GB50263-97 6. 施工中,管网的走向不得擅自改动,如必须改动,请与设计部门联系. Pipe work installation shall strictly follow the design, any change required shall be reported to the designer. 五. 标志在保护区附近,应设置警告牌,警告牌上包括以下的内容：在报警时或释放七氟丙烷 灭火剂时,应立即撤离该地区,在彻底通风前,请七氟丙烷（HFC-227ea）灭火系统设计说明中英文对照4 / 84不要进入该地区.
15、In protected area, sign board shall be installed to state “when alarm for emission of FM200 gas is raised, people shall evacuate from the area immediately”六. 使用事项 OPERATION CONDITION1. 本工程的灭火系统启动操作方式分为自动、手动、机械应急三种. Gas extinguishing system operation include automatic, manual and mechanical for emerg
16、ency.1） 自动：即自动探测报警,发出火警信号.自动启动灭火系统进行灭火.Automatic: By automatic detection of fire, release of fire alarm, extinguish the fire automatically. 2） 手动：即自动探测报警,发出火警信号.经人工电气手动启动灭火系统执行灭火, 上述自动工况的电气手动工况的转换在灭火控制盘上实现,不论灭火控制按钮处于哪一种 工况,当人为发出火警时,都可以使用该火警区的手动控制盒,电气手动启动灭火系统进 行灭火,手动控制盒的另一项功能是它可以在灭火系统动作前,撤消灭火控制盘发出的本 区域的指令,以防止不需由灭火系统进行灭火时启动灭火系统.Manual: By automatic detection of fire, manual operate the gas release mechanism for fire fighting. Under
