《IFR 26650-3000mAh-3.2V -磷酸铁锂电池规格书超详细版.doc》由会员分享，可在线阅读，更多相关《IFR 26650-3000mAh-3.2V -磷酸铁锂电池规格书超详细版.doc（11页珍藏版）》请在金锄头文库上搜索。
1、第 11 页 共 11 页 深圳市银凯动力科技有限公司SHENZHEN YINKAI POWER TECHNOLOGY Co., LtdVER: A地址：广东省深圳市坪山新区金荔科技园4栋 TEL：86（0）0755-2308 8336 FAX：86（0）0755-2308 8396DATE: 2015/10/24Cylindrical LIFEPO4 BatterySpecification圆柱型磷酸铁锂电池规格书MODEL/型号: IFR 26650-3000mAh 3.2V Prepared By/Date编 制/日 期Checked By/Date审 核/日 期Approved By/
2、Date批 准/日 期冯时春/2015.10.24CustomerApproval 客户批准Signature 确认Date 日期Company Name：公司名称：Company Stamp：客户印章：- 保密文件 -Amendment Records （修正记录）Edition(版 本)Description（记 述）Prepared by （编 制）Approved by（批 准）Date（日 期）AFirst Publish冯时春2015/10/241 Scope（适用范围）This specification is applied to the reference battery i
3、n this Specification that manufactured by Yinkai Power Technology Co., Ltd.本说明书适用于本书中所提及的银凯动力科技有限公司制造的电池。2 Product Specification（产品技术规格） Table 1 (表 1)No.(序号)Item（项目）General Parameter(常规参数)Remark（备注）1Rated Capacity（额定容量）Typical（标称容量）3000mAhStandard discharge（0.2C5A) after Standard charge（标准充电后0.2C5A标
4、准放电）Minimum(最小容量)2850mAh2Nominal Voltage（正常电压）3.2VMean Operation Voltage（即工作电压）3Voltage at end ofDischarge（放电终止电压）2.5VDischarge Cut-off Voltage（放电截止电压）4Charging Voltage(充电电压)3.65V5Internal Impedance(内阻)30mInternal resistance measured at AC 1KHZ after 50% charge（半电态下用交流法测量内阻）The measure must uses the
5、 new batteries that within one week after shipment and cycles less than 5 times(使用出货后不到一个星期及循环次数少于5次的新电池测量)6Standard charge（标准充电）Constant Current 0.2C5AConstant Voltage 3.65V0.01 C cut-off（持续电流：0.2C5A持续电压：3.65V截止电流：0.01 C）7Standard discharge（标准放电）Constant current 0.2C5Aend voltage 2.5V（持续电流：0.2C5A截止
6、电压：2.5V） Continuous the table 1 (续 表1)No.(序号)Item（项目）General Parameter(常规参数)Remark（备注）8Fast charge(快速充电)Constant Current 0.5CConstant Voltage 3.65V0.01 C cut-off（持续电流：0.5C持续电压：3.65V截止电流：0.01 C）9Fast discharge(快速放电)Constant current 0.5Cend voltage 2.5V（持续电流：0.5 C截止电压：2.5V）10Maximum Continuous Charge
7、Current(最大充电持续电流)1.0 C11Maximum Continuous Discharge Current（最大放电持续电流）1.5 C12Operation Temperature Range（工作温度范围）Charge（充电）: 0456025%R.H.Bare Cell（电池储存湿度范围）Discharge（放电）: -106013Storage Temperature Range（储存温度范围）Less than 1 year: -2025（小于一年：-2025）6025%R.H.at the shipment state（出货状态时的湿度范围）less than 3 m
8、onths: -2040（小于3个月：-2040）Less than 7 day : -2065（小于7天：-2065）14Cell Dimension（单体电芯尺寸）High/高度：66.20.3 mmInitial Dimension（初始尺寸）Diameter/直径: 26.00.25 mm3 Performance And Test Conditions (电池性能及测试条件)3.1 Standard Test Conditions（标准测试条件）Test should be conducted with new batteries within one week after ship
9、ment from our factory and the cells shall not be cycled more than five times before the test. Unless otherwise specified, test and measurement shall be done under temperature of 233 and relative humidity of 4585%. If it is judged that the test results are not affected by such conditions, the tests m
10、ay be conducted at temperature 1530 and humidity 2585%RH. 测试必须使用出厂时间不超过一个星期的新电池，且未进行过五次以上的充放电循环。除非特别说明，否则测试会在温度233，相对湿度4585%的条件下进行。如果经鉴定测试结果不受上述条件影响，测试也可以在温度1530，相对湿度2585%RH的条件下进行。3.2 Measuring Instrument or Apparatus（测量器具及设备）3.2.1 Dimension Measuring Instrument（尺寸测量器具）The dimension measurement shal
11、l be implemented by instruments with equal or moreprecision scale of 0.01mm. 尺寸测量器具的精度等级应不小于0.01 mm 。3.2.2 Voltmeter（伏特计）Standard class specified in the national standard or more sensitive class having inner impedance more than 10k/V 按照国家标准指定规格等级或采用灵敏度更高的，测量电压时内阻不应小于10k/V。3.2.3 Ammeter（安培计）Standard
12、class specified in the national standard or more sensitive class. Total externalresistance including ammeter and wire is less than 0.01. 按照国家标准指定规格等级或采用灵敏度更高的，包括电流表及电线在内的总外阻应小于0.01。3.2.4 Impedance Meter（电阻计）Impedance shall be measured by a sinusoidal alternating current method(1kHz LCR meter).内阻测试仪测
13、量原理应为交流阻抗法（1kHz LCR）。3.3 Standard ChargeDischarge（标准充放电） 3.3.1 Standard Charge ：Test procedure and its criteria are referred as follows: 标准充电：测试过程及标准如下：0.2C5A =600mA Charging shall consist of charging at a 0.2C5A constant current rate until the cell reaches 3.65V. The cell shall then be charged at c
14、onstant voltage of 3.65 volts while tapering the charge current. Charging shall be terminated when the charging current has tapered to 0.01 C. Charge time: Approx 5.5h, The cell shall demonstrate no permanent degradation when charged between 0 C and 45 C. 电池先0.2C5A恒流充至3.65V，当充电电流逐渐减小时再以3.65V恒压充至电流减小到0.01 C，充电时间大约为5.5个小时。在0-45内充电电池应没有永久损害。3.3.2 Standard Discharge（标准放电）0.2C5A =600mACells shall be discharged at a constant current of 0.2 C5A to 2.5 volts 23 3C电池以0
