《mt-fuji_i_e_a4》由会员分享,可在线阅读,更多相关《mt-fuji_i_e_a4(1页珍藏版)》请在金锄头文库上搜索。
1、Assembly Instructions : One A4 sheet (No.1) Scissors, set square, glue (We recommend stick glue), pencil, used ballpoint pen, toothpicks, tweezers, (useful for handling small parts) Before gluing, crease the paper along mountain fold and valley fold lines and make sure rounded sections are nice and
2、stiff. Glue, scissors and other tools may be dangerous to young children so be sure to keep them out of the reach of young children. Cut out the west and east cross-sections and fold down the tabs on each. Front side of west cross-section Make a right angle. Fold the crater inward first. Incline 4 R
3、ear side of west cross-section Glue incline 4 in position from behind, using tweezers or a similar long, thin utensil inserted through the crater opening. View of completed model Build the east side in the same way Rear side of west cross-section Underside of bottom surface Glue the right- angle sup
4、port to the center of the rear side of the west cross- section. Glue the side tabs of the west and east cross-sections together at right angles. Build the base by connecting western base A and western base B. Western base A Western base B Glue the western base in position along the tabs on the botto
5、m surface. To accomplish this step, its easier to glue the lower tabs in place after first gluing both ends of the western base in position. Glue the inclines in the same manner. Combine these two pieces by gluing then together here Finished! Glue the west cross-section to the east cross-section. Attach the series of parts beginning with the western base and continuing through incline 1, incline 2, and the rest of the inclines to the west cross-section. Japan Mt. Fuji (volcanic structure) : Assembly Instructions 1