《2018美赛精美论文模版版》由会员分享,可在线阅读,更多相关《2018美赛精美论文模版版(3页珍藏版)》请在金锄头文库上搜索。
1、Team Con trol NumberFor office use onlyT1 T2T3T400000Problem Chose nAFor office use onlyF1 F2F3F42018 Mathematical Con test in Modeli ng (MCM) Summary SheetTitle (此处应写论文标题)Summary美赛论文的摘要的英文一般用Summary,摘要最好在本页完成。标题为16号Times New Roman字体加粗并居中摘要为14号Times New Roman字体加粗并居中关键词为12号Times New Roman字体加粗并居左行间距一般
2、为1倍行距,为控制在一页可适当调整。首页不需要页眉和页码。“00000”修改为自己的控制编号 (Team Control Number),“A”改为自己的选题题号 (A/B/C/D/E/F)Key words:三到五个关键词注:红色字为解释说明部分,使用时应全部删除或换成黑色字ContentsI. Introduction 41.1 Background41.2 Our works 4II. The Description of the Problem 52.1 Problem statemen.t52.2 Analysis of Specific Issues 52.2.1 Analysis
3、 of Problem 152.2.2 Analysis of Problem 252.2.3 Analysis of Problem 352.2.4 Analysis of Problem 46III. Basic assumption 6IV. Glossary & Symbols 64.1 Glossary 64.2 Symbols 7V. Models 75.1 Analysis and Solving of Question One75.1.1 Model Preparation 75.1.2 Model Establishment 85.1.3 Results95.1.4 Anal
4、ysis of the Result95.2 Analysis and Solving of Question Two 95.2.1 Model Preparation 95.2.2 Model Establishment 105.2.3 Results105.2.4 Analysis of the Result115.3 Analysis and Solving of Question Three 115.3.1 Model Preparation 115.3.2 Model Establishment 125.3.3 Results135.3.4 Analysis of the Resul
5、t135.4 Analysis and Solving of Question Four135.4.1 Model Preparation 135.4.2 Model Establishment 145.4.3 Results155.4.4 Analysis of the Result15VI. Error Analysis and Sensitivity Analysis 156.1 Error Analysis 156.1.1 Error Analysis of Model One 156.1.2 Error Analysis of Model Two 156.1.3 Error Anal
6、ysis of Model Three166.2 Sensitivity Analysis 166.2.1 Sensitivity Analysis of Model One 166.2.2 Sensitivity Analysis of Model Two 166.2.2 Sensitivity Analysis of Model Three 16VII. Evaluation and Promotion of Model 167.1 Strength and Weaknes.s167.1.1 Strength167.1.2 Weakness: 177.2 Promotion17忸.Conclusions178.1 Conclusions of the problem 178.2 Methods used in our models 17I X. References 18X. Appendix 1810.1 Appendix One1810.2 Appendix Two 18从目录开始有页眉和页码,把“ 00000”改为自己的控制编号,页码会自动调整可以不用编辑