《ai制作木纹效果.doc》由会员分享，可在线阅读，更多相关《ai制作木纹效果.doc（9页珍藏版）》请在金锄头文库上搜索。
1、NotesThis tutorial was created with Illustrator CS3. Keyboard shortcuts are displayed in orange. is displayed for the Command key (mac), with the Ctrl key being the Windows equivalent (not displayed).RectanglesCreate a 5 inch by 5 inch rectangle with the Rectangle Tool (m). An easy way to draw an ex
2、act rectangle is to click on the artboard with the Rectangle Tool (m) to bring up the Rectangle dialog to enter dimensions. Fill the rectangle with a light brown and take off the stroke.Next Copy (c) the rectangle and Paste In Front (f). With the copied rectangle selected, change the dimensions for
3、the width to 2.5 inches and the height to .25 inches in the Transform Panel and fill the rectangle with a 40% black.TextureSelect the smaller rectangle and go Effect Sketch Graphic Pen. When the Graphic Pen Effect dialog comes up, change the following settings. Stroke Length = 15 Light/Dark Balance
4、= 2 Stroke Direction = Vertical Trace and ExpandWith the texture selected go Object Expand Appearance. With the texture still selected, the Control Panel defaults to the Live Trace options. Click the arrow beside the Live Trace Button and select Tracing Options. Or you can go Object Live Trace Traci
5、ng Options. You dont have to change all the options, just the ones below. Mode: Black and White Path Fitting: 1px Minimum Area: 1px Corner Angle: 1 Ignore White: Check this box I like to save a preset in the Tracing Options. It makes it easy to recall these setting. If you have read previous tutoria
6、ls, you will see I use these setting all the time for tracing. Next, press the Expand button on your tool bar.Transform and ColorWith the texture selected, change the width to 5 inches and the height to 5 inches from the Transform Panel. Next, change the color of the texture to a darker brown than t
7、he first rectangle.Warp ToolDouble click on the Warp Tool (shift r) in the Tools Panel to bring up the Warp Tools Options dialog. They are probably on the default settings, but if they are not, press the reset button on the right of the dialog. Once the settings are back to default, change the Inten
8、sity to 10% and click OK.Select just the texture and click and drag with the Warp Tool (shift r). I like to go up and down and slightly back and forth. You can do as much or as little as you want.Twirl ToolClick and hold down on the Warp Tool (shift r) in the Tools Panel to bring up the other transf
9、orm tools. Pick the second tool in the list called the Twirl Tool. With this tool you can add some knots to your wood texture if you want. Double click on the Twirl Tool in the Tools Panel to bring up the Twirl Tool Options dialog. Below are the settings I change. Width =.69 (50pts) Height =.97 (70p
10、ts) Twirl Rate =10 Simplify = 20 With the texture selected, click and hold on the texture until you are happy with the knot. The Twirl Rate is slow so it is easy to see when you need to let go.ExperimentYou can experiment quite a bit with this technique. You can change the dimensions of the Warp Tool and Twirl Tool to create different wood grains and shapes of knots.Below are some example uses of this texture.
