《飞行模拟10(FSX)键盘命令》由会员分享，可在线阅读，更多相关《飞行模拟10(FSX)键盘命令（7页珍藏版）》请在金锄头文库上搜索。
1、文档供参考，可复制、编制，期待您的好评与关注！ 飞行模拟10(FSX)键盘命令请注意: 在使用数字键指令时，确定Num Lock键已经关闭模拟飞行指令（SIMULATOR COMMANDS） 动 作指 令暂停Pause P or BREAK（BREAK）全屏模式Full Screen ModeALT + ENTER（回车键）菜单显示/隐藏Menus (display/hide)ALTATC菜单显示/隐藏 ATC Menu (display/hide)ACCENT（重点符号） or SCROLL LOCK （SCROLL LOCK键）膝板显示/隐藏Kneeboard (display/hide)
2、SHIFT+F10声音开/关Sound (on/off)Q重置当前飞行Reset Current FlightCTRL+; (分号)保存飞行Save Flight; (分号)退出飞行模拟Exit Flight SimulatorCTRL+C立即退出飞行模拟Exit Flight Simulator ImmediatelyCTRL+BREAK（BREAK键）摇杆（禁用/使用）Joystick (on/off)CTRL+K全球坐标/帧频Cycle Coordinates/Frame RateSHIFT+Z选择第一个Select Item 11 选择第二个Select Item 22选择第三个Sel
3、ect Item 33选择第四个Select Item 44选择时间压缩Select Time CompressionR空投物资Drop ObjectsSHIFT+D请求加油车Fuel Truck (request)SHIFT+F航空器标签显示/隐藏Aircraft Labels (display/hide)CTRL+SHIFT+L飞行技巧显示/隐藏Flying Tips (display/hide)CTRL+SHIFT+X增大选择Increase Selection= (等号)缓慢增大选择Increase Selection SlightlySHIFT+= (等号)缓慢减小选择Decreas
4、e Selection SlightlySHIFT+- (减号)减小选择Decrease Selection- (减号)捕获截图Capture ScreenshotV登机桥廊对接/分离Jetway (attach/detach)CTRL+J结束飞行End FlightESC飞机控制面指令（CONTROL SURFACE COMMANDS） 动 作指 令副翼左倾斜Ailerons (bank left) 数字键盘4副翼右倾斜Ailerons (bank right) 数字键盘6副翼左配平Aileron Trim (left) CTRL+数字键盘4副翼右配平Aileron Trim (right)
5、 CTRL+数字键盘6垂直尾翼 左偏航Rudder (yaw left) 数字键盘0垂直尾翼 右偏航Rudder (yaw right) 数字键盘ENTER（回车键）垂直尾翼 左配平Rudder Trim (left) CTRL+数字键盘0垂直尾翼 右配平Rudder Trim (right) CTRL+数字键盘ENTER（回车键）副翼或垂直尾翼居中Center Ailerons and Rudder 数字键盘5水平升降舵向下Pitch Down (elevator) 数字键盘8水平升降舵向上Pitch Up (elevator) 数字键盘2升降舵 向下配平Elevator Trim Down
6、 数字键盘7升降舵 向上配平Elevator Trim Up 数字键盘1襟翼完全收起Flaps (retract fully) F5襟翼缓慢收起Flaps (retract incrementally) F6襟翼缓慢伸出Flaps (extend incrementally) F7襟翼完全伸出Flaps (extend fully) F8扰流板/减速板开/关Extend/Retract Spoilers/Airbrakes / (正斜线)扰流板预位Arm Spoilers SHIFT+/ (正斜线)水舵收/放Water Rudder Up/Down CTRL+W发动机控制指令（ENGINE C
7、OMMANDS） 动 作指 令对于多引擎飞机上，除非你先按下E+引擎号(1-4)选择单个引擎，否则你的操作将对所有引擎生效。要恢复对所有引擎的控制，先按住E，然后快速连续地按下所有引擎号(E, 1, 2,等等)On multiengine aircraft, engine commands affect all engines unless you first select an engine.选择引擎Select EngineE+引擎编号(1-4)选择所有引擎Select All EnginesE+1+2+3+4自动启动引擎Engine AutostartCTRL+E切断节流阀(节流阀就是油
8、门)Throttle (cut)F1反冲力(涡扇发动机/喷气发动机)Reverse Thrust (turboprops/jets)F2 (按住且保持)降低节流阀Throttle (decrease)F2 or数字键盘3增加节流阀Throttle (increase)F3 or数字键盘9节流阀最大Throttle (full)F4螺旋桨低转速Propeller (low RPM)CTRL+F1降低螺旋桨转速Propeller (decrease RPM)CTRL+F2增大螺旋桨转速Propeller (increase RPM)CTRL+F3螺旋桨高转速Propeller (high RPM)
9、CTRL+F4油气混合比设置为慢车低油状态Mixture (idle cutoff)CTRL+SHIFT+F1减小油气混合比Mixture (lean quickly)CTRL+SHIFT+F2增大油气混合比Mixture (enrich)CTRL+SHIFT+F3油气混合比设置为高油量状态Mixture (full rich)CTRL+SHIFT+F4引擎除冰开/关Carb Heat/Engine Anti-ice (on/off)H磁电机选择Magnetos (select)M选择主用电池组或者交流发电机Master Battery/Alternator (select)SHIFT+M选择
10、喷气发动机启动器Jet Starter (select)J直升机旋翼离合器开/关Helicopter Rotor Clutch (on/off)SHIFT+. (句点)直升机旋翼调节器开/关Helicopter Rotor Governor (on/off)SHIFT+, (逗点)直升机旋翼制动器开/关Helicopter Rotor Brake (on/off)SHIFT+B增加选择项目Increase Selection= (等号)逐渐增加选择项目Increase Selection SlightlySHIFT+= (等号)逐渐减小选择项目Decrease Selection Slight
11、lySHIFT+- (减号)减小选择项目Decrease Selection- (减号)通用飞机控制指令（GENERAL AIRCRAFT COMMANDS） 动 作指 令锁定/释放停机刹车Brake (set parking)CTRL+. (句点)后推开始/停止Pushback (start/stop)SHIFT+P (再按1或2使尾部向右或者向左)使用/释放刹车Brakes (apply/release). (句点)使用左刹车Brakes (apply left brake)数字键盘+ (加号)使用右刹车Brakes (apply right brake)数字键盘- (减号)收/放起落架L
12、anding Gear (extend/retract)G尾轮锁定开/关Tail wheel (lock/unlock)SHIFT+G手动放下起落架（若系统失效）Landing Gear (extend manually)CTRL+G燃料供应开/关Fuel Dump (on/off)CTRL+SHIFT+D子面板显示或隐藏Subpanels (display/hide)SHIFT + 1 到 9烟雾系统开/关Smoke System (on/off)I整流罩（通风片）（逐渐）开启Cowl Flaps (open incrementally)CTRL+SHIFT+V整流罩（通风片）（逐渐）关闭C
13、owl Flaps (close incrementally)CTRL+SHIFT+C请求牵引飞机Tow Plane (call)CTRL+SHIFT+Y释放牵引绳索Tow Rope (release)SHIFT+Y舱门选择Doors (select) SHIFT+E（再按1-4以开启/关闭）灯光指令（LIGHT COMMANDS） 动 作指 令全部灯开/关Lights - all (on/off)L机外闪光警示灯开/关Strobe Lights (on/off)O面板灯开/关Panel Lights (on/off)SHIFT+L降落灯开/关Landing Lights (on/off)CT
14、RL+L降落灯（下斜）Landing Light (tilt down)CTRL+SHIFT+数字键盘2降落灯（左斜）Landing Light (tilt left)CTRL+SHIFT+数字键盘4降落灯（右斜）Landing Light (tilt right)CTRL+SHIFT+数字键盘6降落灯（上斜）Landing Light (tilt up)CTRL+SHIFT+数字键盘8降落灯（归正）Landing Light (center)CTRL+SHIFT+数字键盘5无线电指令（RADIO COMMANDS） 动 作指 令ATC窗口（显示/隐藏）ATC Window (display/hide) 重点符 or SCROLL LOCK （SCROLL LOCK键）VOR 1识别开/关VOR 1 Ident (on/off)CTRL+1VOR 1识别开/关 (on/off)CTRL+2MKR识别开/关MKR Ident (on/off)CTRL+3DME识别开/关DME Ident (on/off)CTRL+4ADF识别开/关ADF Ident (on/off)CTRL+5备用频率切换Standby Frequency (swap)XCOM 无线电选择COM Radio (select)CNAV 无线
