《磷酸铁锂电池产品规格书》由会员分享，可在线阅读，更多相关《磷酸铁锂电池产品规格书（12页珍藏版）》请在金锄头文库上搜索。
1、 储能型磷酸铁锂电池规格书STORAGE LiFePO4 BATTERY SPECIFICATIONS客户名称(Customer)： 产品型号(Type)： CF12V60Ah 发行日期(Issuing Date)： Prepared制定 Checked审核 Approved批准 地址(Address)：东莞市南城区新基大道新基大厦310 电话(Tel)：3 传真(Fax)：6 邮箱(E-mail)网址(Website)：1. 适用范围(Product Scope)本规格书描述了由东莞市池能电子科技有限公司生产的锂离子二次电池的技术要求、测量方法、运输、储存及注意事项。This Specifi
2、cation describes the requirements of the lithium ion rechargeable battery supplied by Dongguan Chineng Electronic Technology Co.,Ltd.2. 电池组特性 (Battery Group Specifications) Cell电芯Model 规格型号IFP8081230-10AhCapacity 容量10 AhRated Voltage 标称电压3.2 VInternal Resistance 内阻标准4 mCombination Standard 配组标准A. 容差
3、Capacity Difference1% B. 内阻Resistance()=12 m C. 荷电保持能力Current-maintaining Ability90% D. 电压Voltage3.33.4VCombination Method 组合方式4串6并 4S 6PPile Index成品参数Rated Capacity 标称容量60.0Ah Minimal Capacity 最小容量（0.3C5A）60.0AhNominal Voltage 额定电压12.0VMax. Charge Voltage 最大充电电压14.8 VDischarge cut-off voltage 放电截止电
4、压10.0VCharge Current充电电流5-10AWorking Current 工作电流10AOutput and Input输出端与输入端P+(red) / P-(black)Weight 电池重量 7.2KgDimension 外形尺寸（LWH）168260100mm(不包含外露开关)Charge Method适用充电Standard 标准5A16hrsQuick 快速10A6hrs. Operating Temperature 适用温度Charge充电045；32oF113oFDischarge放电-2060；-4oF149oFManagement system 管理系统Sin
5、gle cell over-charge cut-off voltage单只过压保护值3.9V Charge Working voltage过压释放值3.8VSingle cell under-discharge cut-off voltage单只欠压保护值2.3VDischarge working voltage欠压释放值2.7VConditions of over-charge and under-discharge voltage recovery过、欠压恢复条件With the high-point voltage reaching the working voltage 极限电压达到
6、释放值Over-charge cut-off current 过流保护值40AShort-circuit protection 短路保护Own this ability 具备此功能Condition for the recovery of over-current and short-circuit protection 过流短路保护恢复条件Cut the circuit to automatic recovery 断开负载自动恢复单只电芯曲线图feature curve for single cell3. 技术要求 (Technical Requirements)3.1测试条件(除特别规定)
7、 Testing Conditions (unless otherwise specified) 温 度Temperature: 1535相对湿度Relative Humidity: 45%75%大气压Atmospheric pressure: 86106Kpa3.2充放电性能 (Electrical Characteristics)NO项目(ITEM)测试方法(Testing Instruction)要求(Requirements)1Standard Charge标准充电Charging the cell initially with constant current at 0.5C and
8、 then with constant voltage at 3.7V till charge current declines to 0.05C先用0.5C恒流充电至3.7V，再恒压3.7V充电直至充电电流0.05C2Rated Capacity初始容量Measure discharge capacity with discharge current 1C to 2.5V cut-off within 1 hour after standard charge.标准充电方式充电后，以1C电流放电至2.5V的容量60Ah3Cycle Life循环寿命Measure the capacity af
9、ter 2000 cycles of standard charge and discharge at 1C current to 2.50V cut-off 标准充电方式充电后，1C放电至2.50V，如此循环2000次后电池的剩余容量 80% of Rated Capacity初始容量的80%4Storage Characteristics 储存性能Capacity after 30days storage at 25 from standard charge标准充电方式充电后，25下储存30天后的容量Retention capacity90%剩余容量90%Capacity after 7d
10、ays storage at 60 from standard charge标准充电方式充电后，60下储存7天后的容量Recovery capacity 90%剩余容量90%3.3环境性能 (Environmental Characteristic) NO项目(ITEM)测试方法(Testing Instruction)要求(Requirements)1Temperature testing高低温测试Measure capacity with constant discharge current 0.5C to 2.5V cut-off at each temperature after st
11、andard charge at 25, Percentage as an index of the capacity compared with 100% at 2525下标准充电方式充电后，在指定温度下0.5C放电至2.5V的容量，并以25时放电容量为基准计算百分率70% at 0100% at 2596% at 602Constant temperature /humidity恒定湿热性能Keep the battery at 40 and 90%RH for 96hrs将电池放入温度为40，相对湿度为90%的条件下搁置96小时Recovery capacity 85%恢复容量85%3.
12、4机械性能 (Mechanical characteristics)NO项目(ITEM)测试方法(Testing Instruction)要求(Requirements)1Vibration振动After standard charge, fixed the cell to vibration table and subjected to vibration cycling that the frequency is to be varied at the rate of 1Hz per minute between 10Hz 55Hz, the excursion of the vibrat
13、ion is 1.6mm.The cell shall be vibrated for 30 minutes per axis of XYZ axes. 将标准充电后的电芯固定在振动台上，沿X、Y、Z三个方向各振动30分钟，振幅1.6 mm，振动频率为10Hz55Hz，每分钟变化为1Hz。The battery shall not rupture, smoke, catch fire, vent or leak and the voltage not be lower than 2.5V电池应无破裂、冒烟、着火、泄漏或漏液，并且电压不低于2.5V2IFPacting Testing碰撞Afte
14、r vibration , the battery will be IFPacted 100010 times(6020 times per minute) with the acceleration of 100 m/s2 and pulse lasting time 16ms. 将振动后的电池以峰值加速度为100 m/s2的脉冲撞击100010次(平均每分钟6020次)，脉冲持续时间为16ms3Free fall自由跌落After IFPacting, the battery will be dropped free five times in three mutually perpendicular directions from the height of 1.0m onto a hard board with the thickness of 20mm碰撞实验结
