《JuniperSA发布VMwareview与citrixxendesktop桌面》由会员分享，可在线阅读，更多相关《JuniperSA发布VMwareview与citrixxendesktop桌面（7页珍藏版）》请在金锄头文库上搜索。
1、Juniper SA 发布VMware view与citrix xendesktop桌面一、 使用Virtual Desktops Resource Profile发布的方式用户登陆效果图如下二、 Web resource profile Log into the SA Series as an administrator. Navigate to “Resource profile-Web.” Select type - “Custom.” Enter the configuration for the VMware View target server: Select “Show ALL
2、Autopolicy types.” Enter the URL for the View Connection Server in the “Base URL” input field. The Web Access Control policy should fill automatically after doing this. Select the check box “Autopolicy: Single Sign-on.” Select the radio button “Remote SSO.” Select the check box “POST the following d
3、ata.” Enter the resource, e.g. http:/. Enter the Post URL which is http:/:80/index.jsp (or https). If the authentication server to the SSL VPN is Active Directory, then add the following data including the anglebrackets:Note: If 2-factor authentication is being used, then it will be necessary to con
4、figure a secondary authenticationserver for Active Directory, using the options and in order to send the proper usercredentials for single sign-on.Important: When WSAM is used, a caching override policy must be utilized, as the SA Series marks all content as noncacheableby default. This causes some
5、conflicts with compressed .cab files. To do this, create a “caching” policy withthe proper VMware URL path with /*.cab at the end, and with the setting “Unchanged.”Copyright . 2011, Juniper Networks, Inc. 13APPLICATION NOTE - VMware View with Juniper Networks SA Series SSL VPN AppliancesOnce the VMw
6、are View client is launched, it needs a way to forward the Remote Desktop Protocol (RDP) traffic to thebackend virtual desktop instance. To facilitate this, either the NC or WSAM feature may be used, either of which is probablyalready in use by the remote access users. If users do not have either of
7、 these access methods assigned to them, theadministrator will have to decide which one is most appropriate for a given role and then assign that feature accordingly.1、Network ConnectFor NC configurations, the following elements are required: Enable Network Connect at the users role level. Configure
8、desired NC split tunneling role options. Configure the NC connection profile and IP pool to use. Configure NC access control lists (ACLs) in order to allow access to the View Server and optionally the backendvirtual machines (if Direct Connect is enabled).2、WSAMA、WSAM can work in application mode if View Connection Server is configured with either tunnel or non-tunnel mode.B、WSAM in server mode will work only if VMware View is configured in non-tunnel mode. Only one WSAM mode is required, although both may be used.
