《4.GIS设备二次回路详解》由会员分享，可在线阅读，更多相关《4.GIS设备二次回路详解（23页珍藏版）》请在金锄头文库上搜索。
1、 ABB Group March 28, 2019 | Slide 1,概要 Summary,每个间隔都装有一台就地控制柜，控制柜内包含有所有用于控制、信号传输和连锁的辅助设备。控制柜依靠专用的带编码的多芯连接插头与设备相互连接，彼此不会混淆。 Each feeder bay is equipped with a Local control cabinet that comprises all auxiliaries for control, signaling and interlocking. The devices are connected by mean of device-spec
2、ifically coded multiple connector plugs that can not be mixed-up among each other, ABB Group March 28, 2019 | Slide 2,控制面板panel, ABB Group March 28, 2019 | Slide 3,基本功能 Basic Functions,按钮控制高压开关设备； 位置指示器指示高压开关设备状态； 报警显示 断路器防跳回路； 断路器气室密度过低时闭锁分合闸； 断路器弹簧储能不足时闭锁分合闸； 断路器操作次数计数； 液压泵操作次数计数； 液压泵控制及监视； SF6气体压
3、力监视； 高压设备间隔连锁； 防止带负荷操作隔离开关与接地开关； 断路器在隔离开关故障位置禁止操作闭锁； 双重命令闭锁操作； 手柄插入禁止操作闭锁； 挂锁闭锁； MCB用于保护控制电源回路；,HV-Equipment control with pushbuttons HV-Equipment position identify by position indicators Alarm indication Anti-pumping control of CB Blocking of CB executing at low gas density level in CB compartment
4、Blocking of CB executing at low drive force level CB operation counting Hydraulic pump start counting Control and supervise hydraulic pump Supervise SF6 gas Bay interlocking Protection of disconnector and earthing switchs against under load Interlocking operation of CB under intermediate position of
5、 disconnector Double command lockout in bay level Hand-crank interlocking End position interlock MCB for protection of the different low voltage control circuits, ABB Group March 28, 2019 | Slide 4,基本功能 Basic Functions,除基本功能外，GIS控制还应包含的功能。 MCB用于保护电压互感器二次回路； 零位/就地/远方控制开关； 整站高压设备连锁； 解除连锁钥控制开关； 遥控接口； 就
6、地控制柜照明； 就地控制柜防凝露加热器； 高压设备防凝露加热器,In addition to the basic functions, the following others are included as standard MCB for protection of the low voltage circuit of voltage transformer Off/local/remote switch Interlocking in all bays Interlocking by-pass switch Interface for remote control Cabinet lig
7、hting Cabinet anti-condensation heater HV-Equipment anti-condensation heater, ABB Group March 28, 2019 | Slide 5,设备编号 Identification codes of equipment,电气设备编号根据IEC-60750制定，该标准包含了编制电气设备编号的规则。根据这些规则，电气设备编号可由一系列数字和符号组成的代码加于区分。 高层代码段 例：E03 110kv220kv馈线设备3 位置代码段 例：S 就地控制柜 种类代码段 例：K0A 开关K0分闸接触器 ：端子代码段 例：1
8、1 11号端子,The identification code for electric equipment is laid down in IEC 60750.This standard contains the rules for completing identification codes for electric equipments. According to these rules, identification codes of equipment is separately identified by a series of number and symbol. =Highe
9、r level designation Example:=E03 110kv-220kv feeder 3 +Location Example: +S Local control cubinet -Device Example: -K0A Relay Q0-open function :Terminal designation Example: :11 Terminal 11, ABB Group March 28, 2019 | Slide 6,设备名称综述 Overview device designation,断路器Q0 母线侧隔离开关Q1、Q2、- 馈线侧隔离开关Q9 母线分段隔离开关
10、Q11、Q12、Q21、Q22、- 接地开关Q51、Q52、Q53、- 母线分段接地开关Q15、-、Q19 快速接地开关Q8、Q81、Q82 其他用途隔离开关，如PT用，SA用等Q6,Circuit breaker Q0 Busbar connector Q1,Q2,- Feeder connector Q9 Busbar section disconnector Q11,Q12/Q21,Q22/- Earthing switch Q5,Q51,Q52,- Busbar section earthing switch Q15/-/Q19 Fast action earthing switch
11、Q8,Q81,Q82 Freely available switch Q6,such as PT disconnector,SA disconnector, ABB Group March 28, 2019 | Slide 7,操作机构元器件命名 Drive components designation,断路器操作机构 -Y1 断路器合闸线圈 -Y2/-Y3 断路器分闸线圈 -S1 储能弹簧行程开关 -S0 断路器辅助开关 -K203/-K204/-K206 气压低及储能不足闭锁继电器 -K201/-K301 储能超时时间继电器/合闸闭锁报警延时继电器 -K0E/-K0A 合分闸接触器 -K2
12、08 马达启动接触器 参看断路器操作机构原理图principle drawing of CB mechanism.pdf,CB drive Close coil :-Y1 Open coils:-Y2/-Y3 Spring travel switch:-S1 CB auxiliary switch:-S0 Interlocking relays at low gas pressure and low spring force:-K203/-K204/-K206 Overtime relay of interlocking of pump start :-K201 / overtime rela
13、y of close interlocking alarm:-K301 Close/open connector:-K0E/-K0A Motor connector:-K208 Refer to principle drawing of CB mechanism.pdf, ABB Group March 28, 2019 | Slide 8,操作机构元器件命名 Drive components designation,隔离/接地开关操作机构 -S1 隔离开关辅助开关 -S1A 隔离开关分闸位置限位开关 -S1E 隔离开关合闸位置限位开关 -S1V 隔离开关手动操作限位开关 -S2V 挂锁限位开
14、关 -S5 接地开关辅助开关 -S5A 接地开关分闸位置限位开关 -S5E 接地开关合闸位置限位开关 -S5V 接地开关手动操作限位开关 -Y1 隔离开关闭锁电磁铁 -Y5 接地开关闭锁电磁铁 -K1E/-K1A/-K5E/-K5A 合分闸继电器 参看隔离/接地开关操作机构原理图 Principle drawing of DES mechanism.pdf,DES drive Auxiliary switch of disconnector:-S1 Limit switch off of disconnector:-S1A Limit switch on of diaconnector:-S1
15、E Handle limit switch of disconnector:-S1V Lock limit switch:-S2V Auxiliary switch of earthing switch:-S5 Limit switch off of earthing switch:-S5A Limit switch on of earthing switch:-S5E Handle limit switch of earthing switch :-S5V Disconnector blocking magnet:-Y1 Earthing switch blocing magnet:-Y5
16、Close/open relays:-K1E/-K1A/-K5E/-K5A Refer to principle drawing of DES mechanism.pdf, ABB Group March 28, 2019 | Slide 9,操作机构元器件命名 Drive components designation,快速接地开关操作机构 -S8 辅助开关 -S8A 分闸位置限位开关 -S8E 合闸位置限位开关 -S8V 手动操作限位开关 -Y8R 闭锁电磁铁 -K8E/-K8A 分合闸继电器 参看快速接地开关操作机构原理图 Principle drawing of FES mechanism.pdf,FES drive Auxiliary switch:-S8 Limit switch OFF:-S8A Limit switch ON:-S8E Handle limit switch:-S8V Blocking magnet:-Y8R Close/open rel
