《H3C S5120-SI系列以太网交换机 命令参考-Release 1101-6W104-LLDP命令》由会员分享,可在线阅读,更多相关《H3C S5120-SI系列以太网交换机 命令参考-Release 1101-6W104-LLDP命令(25页珍藏版)》请在金锄头文库上搜索。
1、i 目 录 1 LLDP配置命令. 1-1 1.1 LLDP配置命令 . 1-1 1.1.1 display lldp local-information . 1-1 1.1.2 display lldp neighbor-information. 1-5 1.1.3 display lldp statistics. 1-9 1.1.4 display lldp status . 1-10 1.1.5 display lldp tlv-config . 1-12 1.1.6 lldp admin-status . 1-14 1.1.7 lldp check-change-interval. 1
2、-15 1.1.8 lldp compliance admin-status cdp .1-15 1.1.9 lldp compliance cdp. 1-16 1.1.10 lldp enable . 1-17 1.1.11 lldp encapsulation snap. 1-17 1.1.12 lldp fast-count . 1-18 1.1.13 lldp hold-multiplier . 1-18 1.1.14 lldp management-address-format string .1-19 1.1.15 lldp management-address-tlv.1-19
3、1.1.16 lldp notification remote-change enable .1-20 1.1.17 lldp timer notification-interval. 1-21 1.1.18 lldp timer reinit-delay . 1-21 1.1.19 lldp timer tx-delay . 1-22 1.1.20 lldp timer tx-interval . 1-22 1.1.21 lldp tlv-enable . 1-23 1-1 1 LLDP配置命令 1.1 LLDP配置命令 1.1.1 display lldp local-informatio
4、n 【命令】 display lldp local-information global | interface interface-type interface-number 【视图】 任意视图 【缺省级别】 1:监控级 【参数】 global:显示待发送的全局 LLDP 信息。 interface interface-type interface-number:显示指定端口上待发送的 LLDP 信息,interface-type interface-number 表示接口类型和接口编号。 【描述】 display lldp local-information 命令用来显示待发送的 LLDP
5、 信息,这些信息将被组织成 TLV 发送给邻居设备。 需要注意的是,如果未指定任何参数,将显示待发送的所有 LLDP 信息,包括全局 LLDP 信息以及所有使能了 LLDP 功能且状态为 up 的端口上的 LLDP 信息。 【举例】 # 显示所有待发送的 LLDP 信息。 display lldp local-information Global LLDP local-information: Chassis ID : 00e0-fc00-5600 System name : Sysname System description : System System capabilities sup
6、ported : Bridge,Router System capabilities enabled : Bridge,Router MED information Device class: Connectivity device HardwareRev : REV.A FirmwareRev : 109 SoftwareRev : 5.20 Alpha 2101 SerialNum : NONE 1-2 Manufacturer name : Manufacturer Model name : Model Asset tracking identifier : Unknown LLDP l
7、ocal-information of port 1GigabitEthernet1/0/1: Port ID subtype : Interface name Port ID : GigabitEthernet1/0/1 Port description : GigabitEthernet1/0/1 Interface Management address type : ipv4 Management address : 192.168.1.11 Management address interface type : IfIndex Management address interface
8、ID : 54 Management address OID : 0 Port VLAN ID(PVID): 1 Port and protocol VLAN ID(PPVID) : 1 Port and protocol VLAN supported : Yes Port and protocol VLAN enabled : No VLAN name of VLAN 1: VLAN 0001 Auto-negotiation supported : Yes Auto-negotiation enabled : Yes OperMau : speed(1000)/duplex(Full) PoE