《澳规插头尺寸》由会员分享，可在线阅读，更多相关《澳规插头尺寸（3页珍藏版）》请在金锄头文库上搜索。
1、2.2.3 - Form of pinThe exposed ends and the contact portion of plug pins shall be smooth and free from openings or indentations;Result:The form of pin belongs to (h / i / j) typeLocationsSize (mm)Tolerance (mm)Measured (for both pins, if applicable) (mm)R0.350.05 S0.90.1 T0.60- V6-2.2.4 Insulation o
2、f plug pins 2.8.1 & 2.8.4 Compliance with dimensional requirements of Figure 2.1Method:Plugs up to 15 A complying with Figure 2.1(a), 2.1(c) or 2.1(f) (flat live pins) and of the insulated pin plug type do not need to comply with the R20.0 1 mm requirement of Figure 2.1(e). In addition to the dimens
3、ions of Figure 2.1, the distance between a live pin of any plug and the edge of the moulding of the plug, shall be not less than 9 mm. No point on the front face of the plug shall protrude by more than 0.5 mm. Using a 1.5 mm feeler gauge of greater than 3 mm width and applied without undue force bet
4、ween the plug and the plug gauge, penetration to within 9 mm of the live pin shall not be possible. compliance with the nominal dimensions covering disposition of pins, i.e. spacing from centre and angular orientation, shall be checked by a gauge complying with Appendix A, as appropriate.Result:1. t
5、he distance between a live pin of any plug and the edge of the moulding of the plug, was measured _ mm2. The 1.5 mm feeler gauge (can / can not) penetration to within 9 mm of the live pin LocationsSize (mm)Tolerance (mm)Measured (for both pins, if applicable) (mm) A6.350.15 C (both pins)1.630.15 D (nominal)7.92-(check by gauge) F17.060.4 G 8.6- 1 21.9 max. or 27.0 min.- 221.9 max. or 27.0 min.- 321.9 max. or 27.0 min.- 421.9 max. or 27.0 min.- 560-(check by gauge)660-(check by gauge)7 8.6 - 8 21.0- 920.01.0-101.0- 118.70.5
