《绝缘手套的保护》由会员分享，可在线阅读，更多相关《绝缘手套的保护（2页珍藏版）》请在金锄头文库上搜索。
1、Insulation gloves protection rules绝缘手套保护规定绝缘手套保护规定1. This insulation gloves should store in dry, sunless place, room temperature 1022, clean and dry surrounding.第一 此绝缘手套应保存在干燥，光线阴暗，室 温 1022的环境中清洁和干燥：2. When the gloves become dirty, should be clean with soap and hot water which temperature less than
2、65, and then dry it and put the talc powder. After cleaning, if still found there is oil or painting or something like that, should clean this place immediately with cleaning agent (cannot use too much of cleaning agent!) And then rinse it, and operate as above method. Forbidden to clean with gasoli
3、ne, coal oil or alcohol to clean it! If the insulation glove was wet during using or not dry after cleaning, must be make it fully dry, avoid dry temperature more than 65 .第二 当手套变脏时，要用肥皂和水温不超过65的清水冲洗，然后彻底干燥并涂上滑石粉。洗后如发现仍然沾附有像焦油或油漆之类的混合 物，请立即用清洁剂清洁此部位(但清洁剂不能 过多！)然后立即冲洗掉，并按照上述办法处理。 切忌使用汽油、煤油或酒精之类的 溶剂清洗
4、！在 使用过程中弄湿或清洗后未干的绝缘手套必须彻 底干燥，避免干燥温度超过 65 摄氏度。3. For the insulation glove use frequently, should test it at least every 3 months, for the glove not use frequently, should test it after using every time.第三 经常使用的绝缘手套应至少每隔 3 个月就 测试一次，偶尔使用的手套需在每次使用后测试！4. At any condition, instrument manager should make t
5、he insulation test before issue insulation gloves to production line for using.第四 在任何情况下，仪器管理员将绝缘手套发 给生产线使用前，均要做绝缘检查。5. For the insulation gloves in inventory, should test them every 12 months, interval between the checking times is not allowed more than 12 months.第五 库存的绝缘手套应该每隔 12 个月就测试 一次，间隔时间不能超过
6、 12 个月。6. Insulation gloves test: Make test with Hi-pot testing instrument M086, set testing voltage at 5KV, make Hi-pot test on glove for 20 seconds, leaking current must /=7mA. Test as following pictures: 1) Put the glove into water as following picture, and connect the earth wire of the connectio
7、n instrument into the glove.第六 绝缘手套的测试： 使用 M086 耐压测试仪试，设定测电压 5KV，对手 套进行耐压测试 20 秒，漏电流必须/=7mA 。测 试如下图所示： 1) 如图所示将测试的手套安放在水中，并连接测 试仪器地线在手套中。2) Turn on testing rod, put into the water outside the insulation glove, at this time, the testing voltage should be 5KV, leaking current must less than 7mA.3) 将测试棒开启，在绝缘手套外的水中，此时测 试电压应是 5KV,漏电流必须小于 7mA。
