《箱包验货作业指导》由会员分享，可在线阅读，更多相关《箱包验货作业指导（13页珍藏版）》请在金锄头文库上搜索。
1、Revision History 修改记录修改记录Revision No. 版本版本Date 日期日期Description change 变更履历变更履历Revised by1.0Aug 19, 2010Initial release（新发行）Lennon Wu1.Scope 范围范围This document specifies the general quality requirements for “Sleeping Bag” and other similar products. It is used as a general guideline for inspection if
2、clients have not defined their requirement.此文件为针对箱包及类似产品验货的通用标准。如果客户没有特别的要求，在此定为通用的验货指南2.Inspection Criteria of Product / Package 产品产品/包装验货标准包装验货标准Product: 产产品品Must be without any unsafe defect for using; 不允许有在实际使用中任何对使用者造成伤害的缺陷；Should be free of damaged, broken, scratch, crackle etc. Cosmetic / Aes
3、thetics defect; 不应有任何损坏，破碎，擦伤，或碎裂等外观缺陷；Must be conform to the shipping market legal regulation / clients requirement; 必须符合销往国当地的法规以及客户的要求；The construction, appearance, cosmetics and material of all units should comply with clients requirement / approved samples;产品的结构，外观，材料等必须符合客户的要求或与样品保持一致；All unit
4、s should have full function complying with clients requirement / approved samples;产品功能必须符合客户的要求或与样品保持一致；The marking / label on unit should be legal and clear.产品上的标记/标签必须符合法规要求且清晰明确。Package: 包包装装All units will be adequately packaged, and constructed from suitably robust materials, such that it arrive
5、s in store in a merchantable condition;产品要有足够强度的材料构成的充分包装，使得货物以可销售的状态到达目的仓库；The packaging material can protect the goods from damage during transportation; 在运输过程中，包装材料能防止货物受损；The shipping mark, bar code, label (such as price label), should conform to clients spec. and/or approved samples;箱麦，条形码，标签（例
6、如：价格标签）应符合客户的要求或与样品保持一致；The package should comply to clients requirement / approved samples;包装必须符合客户的要求或与样品保持一致；Text of illustration, instruction, label and warning statement etc. must be clearly printed in users language;图解，说明书，标签，警告声明等应清晰地印有使用者语言；The illustration and instruction on the packaging m
7、ust conform to the product and its actual performance.包装上的图解和说明书必须与实际产品及其功能保持一致；The method and material of pallet/crate etc. should be approved by client.栈板/板条箱包装的材料及方式必须经客户批准3. Inspection Plan seam broken; product damaged 手柄/背带损坏，缝合处破损，或产品破损Fail the shipmentConnector cycle usage test 接头循环使用测试S-1Fit
8、 the connector to its stop & release, 10 times 接头安装到位然后释放，重复 10 次HCrack or fracture 接头开裂XSimulation Usage Test (if applicable, for trolley case only) 模拟路面测试 (若适用，仅针对拉杆箱)1 sampleUnder a load of 0.5kg/liter or labeled claims for 1 hour running as actual use 产品按照每升 0.5 公斤或额定负载进行加载，根据实际使用状况 运行 1 小时IUnit
9、 malfunction or structure fracture 产品功能失效或结构破损Fail the shipmentStuffing material check (if applicable) 填充物检查 (若适用)1 sampleJDissect the unit and visual examine the stuffing material. The material must be clean, free from insect, metal particle, wood splinter and other contamination and unpleasant odo
10、r 将产品剖开，用眼睛检查填充物，填充物需干净，无虫，金属微 粒、木屑以及其他异物，并且无异味Fail the shipmentWater proof test (if applicable) 防水测试 (若适用)1 sample KNot conformed to the intended design as specified in instructions 与产品说明的防水设计不符Fail the shipmentSilk screen printing adhesion test (if applicable) 丝印附着性测试1 sample LThe printing peel of
11、f with 3M 600 tape 用 3M 600 胶带，发现丝印剥落Fail the shipment5Transportation drop check摔箱测试摔箱测试1 cartonDetails please refer to SHWI-HI-G-001 具体请参照产品包装验货通用作业指导书相关章节Note: 备注The above-described defects are those most commonly found, but not necessarily cover all possible defects.以上缺陷描述是普遍存在的，但是可能未覆盖到所有的缺陷.If the factory absence of some kinds of test equipment for the above mentioned field tests & data measurement items, then the inspector should be reported in our inspection report for the reference to client. 如果工厂缺乏以上测量要求所必需的测试设备，验货员要在报告中注明，以供客户参考.
