《北京市某低温热水地板辐射采暖工程设计毕业设计》由会员分享，可在线阅读，更多相关《北京市某低温热水地板辐射采暖工程设计毕业设计（84页珍藏版）》请在金锄头文库上搜索。
1、北京市某低温热水地板辐射采暖工程设计Beijing Low temperature hot water floor radiant Engineering Design届 系专 业 学 号 学生姓名 指导教师 完成日期 摘 要本设计主要是对北京市某住在楼进行低温热水地板辐射采暖的系统设计。该建筑物共二十层，建筑面积为 9607m2，建筑总高 60m，层高 3m，由于建筑高度高于 50m，对建筑在垂直方向上分为高低两个区。 设计主要任务对低温热水地板辐射采暖国内外现状，总负荷为 472kW，由于地板辐射采暖室内实感温度高于设计温度，所以计算时将所得结果取 95%，以满足节能要求。在管道铺设方面，
2、选择了交聚乙烯管道双回形铺设方式，在各户安装温控阀和热计量表，对各用户进行温度控制热盒分户计量。对管网进行水力计算确定管径，根据供热管网的水力计算结果选择用户系统与供热管网的连接方式及用户入口装置，确定换热站的热力计算和设备选型等。本设计所用外网热力热水，外网所提供 95/75热水。在住宅楼的东面建一所换热站，换热后供回水温度 40/30，换热站设备包括换热器、循环水泵、补水泵、除污器等，采暖补水为软化水，定压采用补水泵变频定压形式，采暖水温要求自动控制。换热站内设备要达到结构紧凑，布局合理，经济耐用的要求。最后绘制施工图。关键词：地板辐射采暖 换热站 分户计量 集中供暖AbstractThi
3、s design is mainly to the Beijing one living in low temperature hot water on floor radiant floor heating system design.The building 20 layer, the building area of 9607 m2, building total height 60 m, the layer is 3 m, because building height above 50 m, the architecture in vertical direction into hi
4、gh and low two area. The design of the main task of low temperature hot water floor radiant heating situation at home and abroad, and the total load for 472 kW, because floor radiant heating indoor design temperature higher than those temperature, so will the results calculated from 95%, in order to
5、 meet the energy requirements. In the pipeline, choose the PE pipe into the double form laid means, in each installation temperature control valve and heat meter, the user to temperature control hot box of household metering. The hydraulic calculation of pipe networks to determine diameter, accordin
6、g to the heating network hydraulic calculation results select users system and heating network connections and user entrance device, determine the heat exchanger station thermodynamic calculation and the equipment selection, etc.The design of the network used thermal hot water, the nets provided 95/
7、75 hot water. On the east side of the building to build a heat exchanger station, heat supply and return water temperature after 40/30 , heat transfer station equipment including heat exchanger, the circulating water pump, water supply pump, the decontamination, heating water for water softener, the
8、 constant pressure water supply pump frequency conversion by the constant pressure form, heating water temperature automatic control requirements. Heat exchanger station prepared with to compact structure, rational layout, economical durable requirements. Finally draw construction drawings.Keywords:
9、Radiant floor heating Heat exchanger station Household metering Central heating I目 录绪 论 .10.1 设计的目的和意义 .10.2 工程概述 .10.3 国内外研究现状 .10.3.1 低温热水地板辐射采暖国内研究现状 .10.3.2 低温热水地板辐射采暖国内研究现状 .2第 1 章 设计原始资料和依据 .31.1 设计原始资料 .31.1.1 设计资料 .31.1.2 设计任务 .3第 2 章 采暖方案的确定 .42.1 采暖方案的比较 .42.1.1 地板辐射式采暖 .42.1.2 家用中央空调系统 .52.1.3 家用电锅炉 .52.1.4 电热膜采暖 .52.2 共用立管的布置 .62.3 采暖方案的选取 .
