《开模分析报告范本》由会员分享,可在线阅读,更多相关《开模分析报告范本(6页珍藏版)》请在金锄头文库上搜索。
1、Page 1,Parting line,PL,Cavity,Core,The red line is PL ,please confirm !,Page 2,Texture Area,Red and blue surface:MT11020please draft the red surfaces from 1.5 to 3,Page 3,Gate location(1),Gate type: Sub gateGate size: 1x1,Gate Location,1.If the red surface is texture area,the gate will destroy the s
2、urface of part.2. So suggest cancelling the texture of red surface,or approve the proposa 2 (see next page),Page 4,Gate location(2),Gate type: banana gateGate size: 1x1.5,Gate Location,Suggest gate,Page 5,Sliders (2),SLIDE-2,There will be a Slide insert in the tool. The red line is the insert _ line , please confirm.,Page 6,Draft check (2),Core,Present Design,Suggest Design,0.5,Red surface is undercut, please draft it 0.5 along the core side.,