光传送网技术发展和标准化

上传人:蜀歌 文档编号:146007872 上传时间:2020-09-25 格式:PDF 页数:35 大小:1.48MB
返回 下载 相关 举报
光传送网技术发展和标准化_第1页
第1页 / 共35页
光传送网技术发展和标准化_第2页
第2页 / 共35页
光传送网技术发展和标准化_第3页
第3页 / 共35页
光传送网技术发展和标准化_第4页
第4页 / 共35页
光传送网技术发展和标准化_第5页
第5页 / 共35页
点击查看更多>>
资源描述

《光传送网技术发展和标准化》由会员分享,可在线阅读,更多相关《光传送网技术发展和标准化(35页珍藏版)》请在金锄头文库上搜索。

1、传送网标准化发展 张海懿 工信部电信研究院 2013年9月 传送网国际国内标准组织 国内传送网标准制定(国内传送网标准制定(CCSA TC6 WG1) 吸取国际标准的精华吸取国际标准的精华 从等同到修改采用从等同到修改采用 从完全追随到参与并创新从完全追随到参与并创新 ITU- T SG15 2013- 2016 年传送相关课 题 注-T09指2009- 2012年研究期而T13指2013- 2016年研究期。 T13 课题号课题号 T13课题标题课题标题状态状态 T09 课题号课题号 T09课题标题课题标题 Q5/15 (QG/15) 光纤和线缆的特性与测试方法继续Q5/15的工作Q5/15

2、光纤和线缆的特性与测试方法 Q6/15 (ex. QH/15) 用于地面传输网的光系统特性继续Q6/15的工作Q6/15用于地面传输网的光系统特性 Q7/15 (ex. QI/15) 光部件和子系统的特性继续Q7/15的部分工作Q7/15光部件和子系统的特性 Q9/15 (ex. QK/15) 传输网络的保护/恢复继续Q9/15的部分工作Q9/15传输设备和网络保护/恢复 Q8/15 (ex. QJ/15) 光纤海缆系统的特性继续Q8/15的工作Q8/15光纤海缆系统的特性 Q10/15 (ex. QL/15) 分组传输网的接口、互联、操作维护管 理和设备规范 继续Q10/15和部分Q9/15

3、 的工作 Q9/15 传输设备和网络保护/恢复;运行管理维 护 Q11/15 (ex. QM/15) 传输网的信号结构、接口和互通 继续Q11/15和部分Q9/15 的工作 Q11/15传输网的信号结构、接口和互通 Q12/15 (ex. QN/15) 传输网架构继续Q12/15的工作Q12/15传输网架构 Q13/15 (ex. QO/15) 网络同步和时间分配性能 继续Q13/15和Q15/15的工 作 Q13/15 Q15/15 网络同步和时间分配性能 测试和测量技术与设备 Q14/15 (ex. QP/15) 传输系统和设备的管理与控制继续Q14/15的工作Q14/15传送系统和设备的

4、管理与控制 超100G的工作假设 Minimum bit rate per physical lane for the planned 400G IrDI are assumed to be in the 25- 28Gb/s range (i.e. 1/16th of the total bit rate) Minimum bit rate per optical tributary signal of the multi- vendor IaDI is 50- 56Gb/s (i.e. 1/8th of the total bit rate) Logical lane rate is 5G

5、b/s (i.e. 1/80th of the total bit rate) until more is known about the IEEE decisions on 400GbE Interface rate based on modules of 100G (n x 100G) Only certain values of n will be standardized Initial standardized IrDI rate will be 400G, n=4, and capable of carrying 400GbE New 400G IrDI sized to carr

6、y 4 x ODU4 should be large enough to carry 400GbE All components of the interface go through the same OMS trails, i.e. the new n x 100G OTN signal will be managed as a single entity The n x 100G ”OTU equivalent” signal is a Section layer with no requirement for TCM FEC code(s) for single- vendor IaD

7、I FEC will not be selected or standardized FEC for IrDI will be hard decision FEC Fault isolation may use fault detection mechanisms and/or utilize on demand mechanisms, down to the level of replaceable element or level of potential misconfiguration 城域WDM 速率速率距离距离容量容量ORL属性属性 C2277, C89, C90, C209, C

8、282 1G and 10G WD6- 04 C176, C403, C297 1G, 2.5G and 10G C403 nice to have 100G C2368 1G to 10G C377 10G C2277 55km WD6- 04 20 km and also 100km C2368 40km to 60km C89 40 km C90 10 km, 20 km, 40 km C282, C377, C403 80 km C297 20 to 40 km C2277 128 x 1G or 20 x 10G WD6- 04, C282, C403 40 channels C23

9、68 32 to 40 channels C89, C90, C176 40 to 80 channels C377 8 to 40 channels C297 from 8 to 96 channels C377 27 dB WD6- 04, C 2368, C89, C90, C176, C282, C377, C403 WDM Port agnostic (wavelength adaptive) TEE WD6- 04, C 2368, C89, C90, C176, C282, C377, C403, C297 Bidirectional operation WD6- 04, C17

10、6, C282, C377, C403, C297 Rate upgrade without affecting other channels C403 Rate upgrade without reducing the channel insertion loss C90, C297 Both point to point and rings C377, C90 point to point with OADM C209, C282, C297 Not precluding protection C403 metro EFEC C403, C282 Outdoor capability 主要

11、结论主要结论 Rate: 1G, 2.5G and 10GReach: 80 km Capacity: 40 bi- directional channel system and 80 bi- directional channel system Attributes: WDM Port agnostic (wavelength adaptive) TEE ;Bidirectional operation end- to- end;Rate upgrade without affecting other channels ;Point to Point 城域WDM的性能比较表 ElementS

12、olution 1Solution 2 Maximum rate demonstrated Maximum reach demonstrated Bi- directional end- to- end Capacity (no of bi- dir channels) WDM Port agnostic TEE WDM Port agnostic HEE Rate upgradable Max loss of link Excess loss due to extra devices in link Max demux to TEE distance Which bands can be u

13、tilised? Reflection tolerance Ring capability? Add- drop capability? Protection considerations 网络保护相关建议进展 MPLS- TP: 线性保护标准: 线性保护标准G.8131 通用:多域分段保护通用:多域分段保护 G.mdsp 1) 重点讨论修改了多域分段保护 的单节点互联、双节点互联的网 络功能模型,针对OTN的SNI和 DNI功能模型增加新的研究点; 2)讨论了DNI、多点失效相关的 网络目标,把多点失效作为新研 究点,因时间有限尚未完成讨论, 9月10日安排虚拟会议继续讨论; OTN:共享网

14、状网保护:共享网状网保护G.odusmp 1)针对 1-stage和2-stage协议比较、资源可用性的消息通告、 外部命令、状态机等方面文稿进行了讨论,未达成结论; 2)后续研究内容:消息格式及编码方法;中间节点优先级判 断原则,及如何转发相关消息;端节点桥接何时建立及拆除; 中间节点交叉何时建立及拆除等技术细节。 以太网:点到多点连以太网:点到多点连 接保护接保护G.mecp 1)重点讨论 G.8031 APS协议是 否需要扩展,来实现对E-Tree点 到多点业务保护。 2)阿朗文稿指出 IEEE 802.1Q协 议不禁止叶节点之间OAM帧 (包括APS帧)的转发; ETRI文 稿提出G.

15、8031的1-phase APS进 行每叶保护的方案。 Q9 传送网络传送网络 保护重要标准保护重要标准 1)针对IETF RFC6378 PSC 存在的技术问题,SG15相关专家向 IETF提交了四篇个人文稿,按IETF流程正在推进PSC更新; 2)ITU-T SG15要求IETF及时刷新MPLS-TP线性保护RFC来满足 ITU-T提出的传送需求,以便能够在2014年3月consent G.8131 的修订版。 Tansport SDN的讨论 SPTitleDateStatusRemarks 1Application requirements derived from use cases

16、for transport SDN - 2013- 07- 08 U C149,C0185r2, C389r1 2 SDN control communications channel 2013- 07- 08 UC62, 3 Information elements that may be needed by applications defined in SG 13 2013- 07- 08 UC414, TD71/WP3, C67r3 4 Applicability assessments/gap analysis of existing NMS/EMS/ASON control and management (e.g. G.8080, G.7718) to SDN oriented control and management of transport networks (including consideration of relationship with the SDN work in SG13) 2013- 07- 08 UC46r1, C61r

展开阅读全文
相关资源
相关搜索

当前位置:首页 > 商业/管理/HR > 经营企划

电脑版 |金锄头文库版权所有
经营许可证:蜀ICP备13022795号 | 川公网安备 51140202000112号