《最大实体原则知识分享》由会员分享,可在线阅读,更多相关《最大实体原则知识分享(10页珍藏版)》请在金锄头文库上搜索。
1、Myunghwa Auto Parts Co., Ltd 明和汽車部件(无錫)有限公司,最大实体原则,The design and technical information shown on this document is the property of MIC. It is not to be copied, reproduced, disclosed or used by others, either in whole or in part, without prior written approval of MIC.,研究所,回复:最大实体原则下位置度的计算 分孔和轴两种情况。 对应
2、评价元素的直径公差评价,如果直径公差并未超差,假设实际值对应直径公差带仍有0.2的差值。 那么在配合的时候,位置度超差,但是因为0.2的直径间隙,仍可以顺利装配。这个0.2就对位置度的公差做了补偿bonus. 计算关系就是分孔、轴关系,对应计算直径公差的上、下偏差,纯对位置度的结果进行数学加、减。,最大实体原则,The design and technical information shown on this document is the property of MIC. It is not to be copied, reproduced, disclosed or used by others, either in whole or in part, without prior written approval of MIC.,研究所,Page 3,明和,Page 5,明和,Page 7,明和,Page 8,明和,Page 9,明和,Page 10,明和,