《yajirobe-toucan_i_e_a4》由会员分享，可在线阅读，更多相关《yajirobe-toucan_i_e_a4（4页珍藏版）》请在金锄头文库上搜索。
1、Tools Keep scissors and glue away from small children. Be careful not to cut your fingers when using scissors. Caution Assembly Instructions 1: Carefully cut out the parts. 2: Fold along the dotted lines, making mountain or valley folds as indicated. 3: Attach the glue tabs on each part to assemble
2、the model. (Read the assembly instruction for more information.) 4: Attach the parts in order. (Read the assembly instruction for more information.) 5: Your paper craft model is finished! Scissors, glue (We recommend craft glue.) Explanation of Symbols Cut line Valley fold Mountain fold Glue up to t
3、his line Glue tab Attach to a point within the same piece Glue tab Attach to a separate piece Glue together Insert (Do not apply glue) A balancing toy is a toy that rocks back and forth without falling over, due to its center of gravity being below the fulcrum point. This balancing toy is based on a
4、 toco toucan, with its distinctive large beak. Its beak and wings also move as it rocks. Find the proper balance and have fun playing! Balance Toy “Yajirobe“ (Toco Toucan) Balance Toy “Yajirobe“ (Toco Toucan) : Assembly Instructions 1. Assemble and and attach them together. 2. Assemble and attach it
5、 to . 3. Fold and glue down and . Next, assemble , glue and to the inside, and attach . Lastly, glue together so that it is covered. Do not put glue on this glue tab yet. Put glue here. Assembling the main part Fold and glue together here. Fold and glue together here. Balance Toy “Yajirobe“ (Toco To
6、ucan) : Assembly Instructions 4. Adjust the balance of the bottom part of the beak and insert it into the body. 6. Attach and to . Next, glue , , and to . Once it is balanced, add glue. Place it on a vertical piece of paper to adjust the balance. If the beak side seems too light, continue adding to
7、the inside of until it is balanced. Insert into the back of the body to attach. Simply attach and do not glue. 5. Assemble and , and and attach each together. Assembling the tail Place glue here only. Attach and so that they are held between and . Balance Toy “Yajirobe“ (Toco Toucan) : Assembly Inst
8、ructions 7. Assemble and attach and and assemble and . Next, glue , , and to . 8. Assemble and and attach them together. Assembling the stand 9. Assemble and then attach it to . Lastly, place the Toucan on the stand and it is complete. Put glue only on the longest glue tab. Close the flap after attaching and to each other. Place glue here only. Close the flap after attaching and to each other. Assembling the weight Fold and glue down . Then, assemble and place inside before finishing. Balance Toy “Yajirobe“ (Toco Toucan) : Assembly Instructions
